Engineering Commons^™

Life Cycle Assessment Of Air Classification As A Sulfur Mitigation Technology In Pine Residue Feedstocks, Ashlee Edmonson

Theses and Dissertations--Biosystems and Agricultural Engineering

Sulfur accumulation during biofuel production is pollutive, toxic to conversion catalysts, and causes the premature breakdown of processing equipment. Air classification is an effective preprocessing technology for ash and sulfur removal from biomass feedstocks. A life cycle assessment (LCA) sought to understand the environmental impacts of implementing air classification as a sulfur-mitigation technique for pine residues. Energy demand and material balance for preprocessing were simulated using SimaPro and the Argonne National Laboratory’s GREET model, specifically focusing on comparing the global warming potential (GWP) of grid electricity versus bioelectricity scenarios. Overall, the grid electricity scenario had a GWP impact over 7 …

Unmanned Aircraft Systems For Precision Meteorology: An Analysis Of Gnss Position Measurement Error And Embedded Sensor Development, Karla S. Ladino

Theses and Dissertations--Biosystems and Agricultural Engineering

The overarching objective of this research was to enhance our comprehension of the three-dimensional precision of meteorological measurements obtained using small unmanned aircraft systems (UAS). Two complimentary experiments were conducted to achieve this objective.

The first experiment entailed the development and implementation of a system to determine the global navigation satellite system (GNSS) position accuracy on a UAS platform. This system was utilized to assess the static and dynamic accuracy of L1 and L1/L2 GNSS receivers in real-time kinematic (RTK) and non-RTK fix modes. Adjusted two-sample t-tests revealed significant differences in horizontal and vertical error between RTK and non-RTK receivers …

Comparing Beopt (Energyplus) Energy Predictions To Measured Circuit Level Energy Consumption Of 12 Similar Small Energy-Efficient Single-Family Residences, Braydi Mcpherson-Hathaway

Theses and Dissertations--Biosystems and Agricultural Engineering

Residential energy usage patterns change as a result of new building codes, renewable technologies, household electronics, and changes in occupancy habits. Building simulations have used end-use energy studies to inform occupancy profiles and overall usage characteristics for the building simulations. Building simulations allow designers, engineers, policymakers, code developers, and building owners to model proposed designs to new and existing buildings, thus it is imperative that the energy profiles used in the models are accurate. In this study, the building simulation engine BEopt is used to model energy-efficient homes recently constructed in Southern Kentucky. The homes have well defined building characteristics …

Modeling Energy Flows In Floating In-Pond Raceways Utilizing Solar Power Back-Up, Bo Smith

Theses and Dissertations--Biosystems and Agricultural Engineering

The In-pond Raceway (IPR) is a novel option for production aquaculture, depending on water moving devices to provide constant flow. Device failure may result in catastrophic fish loss, requiring power backup systems to mitigate risk in case of power outages. Because these systems must be dependable and many suitable locations are remote, off-grid solar photovoltaic (PV) systems with battery storage have been considered since they eliminate need for utility power. Such systems can be hard to size and expensive. This study modeled system requirements using an energy balance to determine whether systems could withstand varying loads based on climatological conditions. …

Assessing The Spatial Accuracy And Precision Of Lidar For Remote Sensing In Agriculture, Surya Saket Dasika

Theses and Dissertations--Biosystems and Agricultural Engineering

The objective of this whole study was to evaluate a LiDAR sensor for high-resolution remote sensing in agriculture. A linear motion system was developed to precisely control the dynamics of LiDAR sensor in effort to remove uncertainty in the LiDAR position/velocity while under motion. A user control interface was developed to operate the system under different velocity profiles and log LiDAR data synchronous to the motion of the system. The LiDAR was then validated using multiple test targets with five different velocity profiles to determine the effect of sensor velocity and height above a target on measurement error. The results …