Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Electrical and Computer Engineering

PDF

Technological University Dublin

2010

Edge filter

Articles 1 - 4 of 4

Full-Text Articles in Engineering

Optimum Design For Maximun Wavelength Resolution For An Edge Filter Based Ratiometric System, Qiang Wu, Ginu Rajan, Pengfei Wang, Yuliya Semenova, Gerald Farrell Jan 2010

Optimum Design For Maximun Wavelength Resolution For An Edge Filter Based Ratiometric System, Qiang Wu, Ginu Rajan, Pengfei Wang, Yuliya Semenova, Gerald Farrell

Articles

In this letter, we propose a high resolution temperature insensitive interrogation technique for FBG sensors where one FBG acts as an edge filter to interrogate a separate FBG sensor. A high resolution of better than 5 με in strain measurement range from 0 to 1100 με and the best resolution of better than 1 με were verified by experiments. An error of only ±2.2 με is achieved over a temperature range from 15 to 50 °C, indicating that this strain interrogation technique is temperature insensitive. Using an altered system configuration, the temperature was also measured simultaneously with a resolution better …


A Study Of The Effect Of The Position Of An Edge Filter Within A Ratiometric Wavelength Measurement System, Qiang Wu, Pengfei Wang, Yuliya Semenova, Gerald Farrell Jan 2010

A Study Of The Effect Of The Position Of An Edge Filter Within A Ratiometric Wavelength Measurement System, Qiang Wu, Pengfei Wang, Yuliya Semenova, Gerald Farrell

Articles

The effect of the position of an edge filter within a ratiometric wavelength measurement system was investigated based on three cases: (1) the reflected fibre Bragg grating (FBG) signal passes through both the reference arm and the edge filter arm, (2) the reflected FBG signal is connected directly to the edge filter arm and does not pass through the reference arm, (3) the edge filter sits in line with the FBG and thus the source power is filtered prior to reaching the FBG. Both numerical simulations and experimental results show that cases 1 and 2 have similar system performance whilst …


Temperature Performance Of A Macrobending Single-Mode Fiber-Based Refractometer, Pengfei Wang, Yuliya Semenova, Qiang Wu, Zie Zheng, Gerald Farrell Jan 2010

Temperature Performance Of A Macrobending Single-Mode Fiber-Based Refractometer, Pengfei Wang, Yuliya Semenova, Qiang Wu, Zie Zheng, Gerald Farrell

Articles

The temperature dependence of polarization-dependent loss (PDL) for a macrobending standard single-mode fiber (SMF28) is investigated both theoretically and experimentally. The experimental results show an overall agreement with the proposed theoretical model over a temperature range from 0 C to 70 C. An SMF28-based edge filter is used as an example regarding temperature- dependent PDL performance. It is shown that the temperature variations have a significant influence on the polarization dependence of macrobending loss, and further impact on such a fiber bend loss edge filter used in a wavelength measurement application. It is also concluded that by using the proposed …


Simple Design Technique For A Triangular Fbg Filter Based On A Linearly Chirped Grating, Qiang Wu, Gerald Farrell, Yuliya Semenova Jan 2010

Simple Design Technique For A Triangular Fbg Filter Based On A Linearly Chirped Grating, Qiang Wu, Gerald Farrell, Yuliya Semenova

Articles

A novel and simple design technique for triangular spectrum response of fibre Bragg grating (FBG) is pre- 21 sented based on a linear chirped grating. It is shown that this method is fast and can give a straightfor- 22 ward solution to meet a design target. The numerical simulation examples verified the effectiveness of 23 the design method. A general approach to design for multichannel triangular spectral responses for 24 FBG filters is proposed, which provides a solution that achieves a minimum change of refractive index 25 for the fibre.