Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Added Mass Computation For Control Of An Open-Frame Remotely-Operated Vehicle: Application Using Wamit And Matlab, You-Hong Eng, Cheng-Siong Chin, Michael Wai-Shing Lau Aug 2014

Added Mass Computation For Control Of An Open-Frame Remotely-Operated Vehicle: Application Using Wamit And Matlab, You-Hong Eng, Cheng-Siong Chin, Michael Wai-Shing Lau

Journal of Marine Science and Technology

In this paper, numerical modeling and testing of a complexshaped remotely-operated vehicle (ROV) are shown. The paper emphasizes on systematic modeling of hydrodynamic added mass using computational fluid dynamic software WAMITTM on the open frame ROV that is not commonly applied in practice. From initial design and prototype testing, a small-scale test using a free-decaying experiment is used to verify the theoretical models obtained from WAMITTM. Simulation results have shown to coincide with the experimental tests. The proposed method is able to determine the hydrodynamic added mass coefficients of the open frame ROV.


Combined Traction And Energy Recovery Motor For Electric Vehicles, James Long, Xin Wang, Claude Kansaku, Brian Moravec Jul 2014

Combined Traction And Energy Recovery Motor For Electric Vehicles, James Long, Xin Wang, Claude Kansaku, Brian Moravec

TREC Final Reports

Electric vehicle manufacturers are looking for ways to optimize energy use for vehicle range extension and reduction of battery capacity. Electric motors have lower efficiencies at very low speed and high torque. This is typically at vehicle launch from standstill, at very low speeds, and during energy regeneration at lower speeds and approaching standstill. The KersTech solution is a breakthrough technology allowing supplement of the electric drive with a hydraulic drive, active in lower speeds ranges, dropping out as the electric motor takes over in its higher efficiency range of operation. The report consists of four parts. Part I presents …