Engineering Commons^™

The Influence Of Different European Cements On The Transport And Early-Age Properties Of Concrete In The Cover-Zone, Niall Holmes, L. Basheer, S. Nanukuttan, Pam. Basheer, W. J. Carter, T. M. Chrisp, G. Starrs

Conference papers

The use of in situ tests for performance based specification would require demonstration of their suitability to distinguish the quality of concrete. With the introduction of new European Standards for cements, this would mean concretes produced with these new cements should be classified for their quality using the performance tests. It is generally believed that transport properties of concrete are related to their durability and hence the measurement of these properties can form the basis of performance based specifications. This paper reports data indicating that transport properties measured at 28-days for concretes manufactured with different European cements and water-binder ratios …

Portland Cement Concrete Pavement Permeability Performance, Javier Castro, Robert Spragg, Phil Kompare, W. Jason Weiss

JTRP Technical Reports

The objective of this project was to evaluate the transport properties of concrete pavement in the state of Indiana using common testing procedures. Specifically this work evaluated the absorption of water, the absorption of deicing solutions, and electrical conductivity. A series of concrete paving mixtures were tested to provide a range of values that were typical for the state of Indiana. While similar mixture proportions were used for the mixtures in Indiana differences in the magnitude of water absorbed occurred. A series of mortars were tested to illustrate the effect of curing conditions, water to cement ratio, and paste volume. …

Performance Evaluation Of Open Graded Base Course With Doweled And Non-Doweled Transverse Joints, Robert Schmitt, Samuel Owusu-Ababio, James Crovetti

Transportation Reports with the Wisconsin Department of Transportation

The objectives of this study were to investigate the performance of 20-year old doweled/non-doweled and dense-graded/permeable base test sections on three concrete pavement segments in Wisconsin: USH 18/151 in Iowa and Dane counties, STH 29 in Brown County, and USH 151 in Columbia and Dane Counties. Five pavement bases were placed including: dense graded, asphalt-stabilized permeable, cement-stabilized permeable, and untreated permeable having two gradation sizes.

USH 18/151 test sections had similar performance (PDI) for doweled unsealed pavement on dense and permeable base. Distresses common to all segments included slight to moderate distressed joints/cracks and slight transverse faulting. Asphalt-stabilized permeable base …

Developments In Intelligent Monitoring Of Concrete Structures, T. M. Chrisp, G. Starrs, W. J. Mccarter, E. H. Owens, S. V. Nanukuttan, Niall Holmes, L. Basheer

Conference papers

Deterioration in concrete comprises an initiation period and a propagation period. The initiation period is characterised by changes that occur within the concrete in response to the exposure environment and continues until a stage is reached when damage begins to propagate. The propagation period begins at a point in time defined when a particular event occurs (e.g. loss of steel passivity due to chloride ingress) and continues until a specified limit state is reached. The initiation and propagation stages of a deterioration process result from a complex interaction of physical, chemical and electrochemical phenomena. Prediction of the field performance of …

Affordable Lightweight High Performance Concrete (Alwhpc) - Expanding The Envelope Of Concrete Mix Design, Kevin J. Simons

Department of Construction Engineering and Management: Dissertations, Theses, and Student Research

One way to reduce excess material would be to lighten the load on a structure with the use of affordable lightweight high performance concrete (ALWHPC). Most or all lightweight high performance concrete mixes used today include lightweight aggregates as the coarse aggregate and sand for the fine aggregate. ALWHPC mix designs contain all lightweight aggregates and cementitious materials that are readily available throughout the United States. Instead of 115 – 120 pcf, ALWHPC mix designs range from 88 – 100 pcf and strengths from 2,700 – 8,700 psi compressive strength. This research will explore the use of local lightweight aggregates …

High-Performance Concrete Bridge Decks: A Fast-Track Implementation Study Volume 2: Materials, Mateusz Radlinski, Jan Olek

JTRP Technical Reports

The purpose of this research was to examine the applicability of ternary binder systems containing ordinary portland cement (OPC), class C fly ash (FA) and silica fume (SF) for bridge deck concrete. This was accomplished in two parts, the laboratory part and a field application part.

During the laboratory studies, four ternary mixtures, each containing either 20% or 30% FA and either 5% or 7% SF were subjected to four different curing regimes (air drying, 7 days curing compound application and 3 or 7 days wet burlap curing). In general, all four ternary mixtures exhibited very good water and chloride …

Historic Bridge Evaluation Using Finite Element Techniques, Helena M. Charron

Masters Theses 1911 - February 2014

The present study examined the application of modern, computer-based analysis methods to two existing historic bridges in Massachusetts. The first bridge featured in this study is the Woronoco Bridge, a reinforced concrete open spandrel arch bridge that was constructed in 1923. It was hoped that a computer-based, parametric study of this bridge would prove it to be deck-stiffened, similar to select bridges of Swiss engineer Robert Maillart. However, the results do not support that there was any intent to reduce bending in the arch as a result of increasing the stiffness of the bridge deck. Instead, the Woronoco Bridge appears …

An Innovative Concrete Practice Performance Measurement Towards Environmental Improvement In Malaysia, Hilmi Mahmud

Hilmi Mahmud

The environmental impact from the concrete construction industry is quite alarming. The industry is embarking into improving the concrete performance and exploring into alternative materials to reduce such impact. An area which is lacking is improvement in the quality of concrete practice itself. By having good concrete practice, a good quality concrete can be achieved. This paper proposed a performance measurement of concrete practice and applies the measurement to assess the quality of concrete practice for a concrete structure project in Malaysia. © 2010 IEEE.

The Use Of Novel Non-Destructive Methods For Quality Control And Performance Evaluation Of Concrete Structures, Sree Nanukuttan, Niall Holmes, Sudarsan Srininvasan, Lulu Basheer, Muhammed Basheer, John Mccarter, Gerry Starrs

Conference papers

Concrete cover provides the first line of defense against the ingress of many deleterious substances into the concrete. Therefore, a measure of its transport properties is vital in assessing its long term performance in a given exposure condition. In new structures the rate of ingress of the deleterious substances could be monitored using array of electrical sensors that are embedded in the cover concrete. For structures that are currently in service, tests can be performed by removing cores from the structure (lab based tests) or by using tests that can be performed on the surface (in situ tests). Results relating …

Developments In Monitoring Techniques For Durability Assessment Of Cover-Zone Concrete, W.J. Mccarter, T. M. Chrisp, G. Starrs, Niall Holmes, L. Basheer, M. Basheer, S. V. Nanukuttan

Conference papers

This paper outlines developments in the use of an embedded multi-electrode sensor to study the response of the cover-zone (surface 50mm) to the changing ambient environment. The sensor enables the measurement of the spatial and temporal distribution of the electrical properties of concrete and temperature within the cover-zone thereby allowing an integrated assessment of cover-zone concrete performance. Both laboratory and field results are presented to highlight the information that can be obtained from embedded sensors. When exposed to the natural environment, the temperature dependence of the electrical response is highlighted and standardization protocols are developed to account for this effect. …

Performance Of Reinforced Concrete Columns Strengthened With Fiber Reinforced Polymers Under Various Loading Conditions, Mohamed Gamal Mohamed El Sayed

Theses

Strengthening of reinforced concrete (RC) structures with Carbon Fiber Reinforced Polymer (CFRP) composites has been a popular subject that attracted considerable attention from researchers for the last two decades. The high specific strength, stiffness, environmental resistance, and ease of application make CFRP composites highly desirable for strengthening and rehabilitation of RC structural components.

For concentrically loaded RC members with a circular cross-section, the lateral CFRP-confinement of concrete results in a substantial increase in load capacity and ductility. CFRP-confinement is less effective for RC compression members with square and rectangular cross-sections due to stress concentration at the corners and lack of …