Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Engineering

An Experimental Study Of Lateral Soil Pressures And Moments On Flexible Sheet Piles, James H. Donahue Jul 1970

An Experimental Study Of Lateral Soil Pressures And Moments On Flexible Sheet Piles, James H. Donahue

Civil & Environmental Engineering Theses & Dissertations

In order to study the effect compaction has on lateral earth pressures exerted on and bending moments in steel sheet pile bulkheads, an experimental study was undertaken which employed the placement of a non-cohesive soil at two specific densities against three model piles of varying thicknesses. The soil was placed both in a loose and a dense state and the bending strains and deflections of the sheet piles were measured at various stages of backfill. Surface loadings were then placed after completion of the backfilling to observe the effects these loads had on the bending moments. The results of the …


Grain Size Reconnaissance Of The Virginia-North Carolina Inner Shelf Analysis By Settling Technique, Robert Bailey Sanford Jr. Jul 1970

Grain Size Reconnaissance Of The Virginia-North Carolina Inner Shelf Analysis By Settling Technique, Robert Bailey Sanford Jr.

OES Theses and Dissertations

The 2-fold purpose of this study is to calibrate a Rapid Sediment Analyzer and to use it to aid in the determination of the genesis of sediment on the inner continental shelf between Cape Henry and Cape Hatteras. Rapid Sediment Analyzer calibration was conducted by comparison of sieving and settling results of similar sands.

The study area was divided into sediment provinces by both a qualitative procedure (grain size and topography) and a quantitatively procedure (factor-vector analysis). Qualitative provinces are beach and surf, upper shore face, lower shore face, sea floor, and terminal shoals. The berm fines from each terminal …