Engineering Commons^™

Fracture Energy And Tensile Behavior Of Concrete, Wen-Jinn Chiou

Theses

Fracture behavior of concrete has been a subject of investigation for the past two decades. The need of understanding the complete tensile response of concrete is absolutely essential for theoretical modelling as well as design application of plain concrete structures.

In this study, attempts were made to investigate the validity of two important fracture parameters, namely, the fracture energy and the critical crack tip opening displacement. Three types of test specimen, dog- bone shaped tension specimen, notched beam and compact tension specimen, were investigated. These tests were conducted using the closed-loop MTS 810 strain-controlled testing system. For the uniaxial tension …

Behavior Of Tee-Shaped Reinforced Concrete Columns Subjected To Biaxial Bending And Axial Compression, Antoun Romanos Nader

Theses

The investigation deals with the effect of eccentric loading on the moment-curvature relationship of reinforced concrete tee columns.

The test program consisted of two series of tee-shaped reinforced concrete columns, loaded biaxially at constant angle from the principle axes. Their end conditions were assumed to be pinned-ended.

Loads, at constant rate, were gradually applied until failure. At each loading stage, measurements were made for the strains and deflections at the mid span section.

The experimental and theoretical results of the load- deformation and moment-curvature were compared and found that the analytical approach proposed by Hsu is applicable to irregular sections …

Failure Surface For L-Shaped Reinforced Concrete Short Columns, Mon-Chen Liu

Theses

Combined bending and axial compression for L-shaped reinforced concrete short columns is a common problem. But the present ACI Building Code (ACI 318-77), handbooks and texbooks pay no attention to this problem. A numerical analysis and computer program developed by Hsu fora reinforced concrete member subject to biaxial bending and axial load has been used Using this computer program, the interaction diagrams and failure surface were developed for L-shaped members under combined bending and axial compression. A comparison between theoretical and experimental results was included to examine the validity of failure surface.

Analysis And Tests [Of] L-Shaped Reinforced Concrete Column Under Combined Biaxial Bending And Axial Compression, Alaedin Majlesi

Theses

A total of five tests on biaxially loaded column specimens were conducted to investigate the complete behavior of load-deformation characteristics from zero load until failure. The specimens were tested under horizontal position with 60 ton hydrolic jack. Pin end was used for both ends to obtain higher accuracy of plotting curves.

Two specimens were tested with dial gages to obtain load-deflection curves and the other three specimens were tested with demec and strain gages to obtain load strain and moment-curvature curves. The strain gages were measured by weston bridge and deme-gages were measured by mechanical dial gage.

The above moment-curvature …