Engineering Commons^™

Industrial-Grade Monitoring Solution: Hoistcam, Purdue Ect Team

ECT Fact Sheets

Safety and productivity are top priorities for contractors and industrial operations. Improving either makes a company more profitable and competitive. Technology advancements that can do both are important for every company to consider. HoistCam^TM industrial-grade video monitoring solutions can improve employees’ productivity and workplace safety in the construction industries. HoistCam also improves efficiency of operations and reduces job site accidents resulting in substantial cost savings to a contractor.

HoistCam™ is an integrated, wireless video system. The use of HoistCam eliminates blind lifts, blind spots and can share the live video with anyone, anywhere with solid security and easy control. …

Mining Big Data To Create A Tool For Empirical Observation Of Continuous Safety Improvement In A Construction Company - A Progressive Case Study In The Lean Environment, Nicolas J. Michuda

Open Access Theses

In any iterative process, without a system of measurement, controlled improvement cannot be recorded. This is especially true in the construction industry, where error occurs, often with fatal repercussions. As part of a process to facilitate the establishment of this metric, an entirely new application was created. The goal of this application is to measure the causal factors that lead to incidents, which will allow the user and administration to track the circumstances and types of incidents. This enables the company to focus on these problem areas and improve through training. By analyzing these incident trends over time, the company …

Worker Injury Prevention Strategies, Carlos A. Ferreira-Diaz, Alma Torres-Zapata, Christopher A. Nanovic, Dulcy M. Abraham

JTRP Technical Reports

As the trend of increased highway construction and/or rehabilitation continues to grow, the public often demands that delays in work zones be kept to a minimum. Thus, the flow of traffic through the construction zone must be maintained while performing pavement maintenance/ repair/ reconstruction activities. At the same time, the safety of personnel and property in highway construction work zones must be ensured. Three types of risks are encountered by construction and maintenance workers in construction workzones: (a) risks due to underprotection or lack of protection against potential hazards (including lack of hearing protection, eye protection, respiratory protection); (b) effect …

Investigation Of The Effective Use Of Warning Lights On Indiana Department Of Transportation (Indot) Vehicles And Equipment, Bob Mccullouch, Brandon Stevens

JTRP Technical Reports

This study was requested by INDOT to determine if current lighting packages used on INDOT maintenance vehicles, specifically snow plow vehicles, can be improved with other commercially available products. Different light products were obtained from various vendors, mounted on INDOT vehicles, and visual comparisons were performed under various lighting and weather conditions by a team of observers. The comparison evaluations were performed revealing that other light packages, LED models for most options, were brighter and certain colors more visible. The preferred light models are recommended. These recommendations were forwarded to appropriate individuals that make these decisions at INDOT. Implementation is …

Risk Assessment Of Various Median Treatments Of Rural Interstates, Natalie M. Villwock, Nicolas Paul Blond, Andrzej P. Tarko

JTRP Technical Reports

This report presents results of a comprehensive study that evaluates the safety impacts of alternative median treatments on rural freeways. Extensive data were obtained from Indiana, Colorado, Illinois, Iowa, Missouri, New York, Ohio, Oregon, Washington, and Wisconsin. The studied median treatments include AASHTO-recommended treatments: depressed medians, depressed medians with high and lowtensioned cable barriers, and flush medians with concrete barriers. Other treatments used in the freeway design were also studied: medians with berms, sloped medians, and depressed medians with berms. Negative binomial models were developed to predict the frequency of crashes in three categories: single vehicle (SV), multiple vehicles same …

Cranium: Device For Improving Crane Productivity And Safety, Purdue Ect Team

ECT Fact Sheets

Cranes are the most important pieces of equipment on many construction sites. CRANIUM is a video system designed to improve productivity and safety of crane operations by improving communications. A video camera mounted on the crane bottom transmits an image to the television monitor in the crane cab. The operator has a real-time picture of the loads and craftsmen that might otherwise be out of the direct line of sight.

3m Personal Air Monitoring Systems, Purdue Ect Team

ECT Fact Sheets

3M monitors are made to allow sample desorption directly in the monitor itself. The monitor comes with a snap-on elution cap that permits the desorbing solvent to be injected into the monitor. The solution is then poured into sample vials for analysis. 3M monitors use standard analytical methods: gas chromatography for the organic vapor monitor and ethylene oxide monitor, and colorimetry for the formaldehyde monitor.

Delmia Safework®Pro™ : Human Modeling, Purdue Ect Team

ECT Fact Sheets

Manufacturers and designers strive to develop products that conform to all relevant Health and Safety standards and are "user-friendly" while still maximizing the productivity of their own workforce. Digital human modeling technology can assist a designer to determine the performance of people in the context of a workplace or a product before it exists and throughout its entire lifecycle. SAFEWORK’S accurate manikin has the highest number of Anthropometric Variables (104), Segments (99) and Degrees of Freedom (149). It also has fully articulated spine & hand models as well as joints with coupled range of motion. Moreover, it’s unique Multivariate Algorithm …

Pipeman:Safety In Trenches, Purdue Ect Team

ECT Fact Sheets

Even though heavy construction equipment such as a crane or backhoe excavator, is used to perform the task of pipe laying in the trench, workers are required to be inside the trench to guide the excavation, pipe laying, and final alignment. Work place safety has become a major concern in the construction industry over the past few decades, and trench cave-ins have caused serious and often fatal injuries to workers in the United States. The Construction Automation and Robotics Laboratory(CARL) at North Carolina State University has developed an alternative which involves advanced new technology: the prototype robotic excavation and pipe …

Behavior-Based Safety In Construction, Purdue Ect Team

ECT Fact Sheets

Behavior-based safety approach that was introduced into the United States in 1930's and has been popular in manufacturing area since 1980's assumes that many of injuries and illnesses are the result of unsafe acts by workers. Behavior-based safety is a proactive approach to increasing safety in the workplace and in the community. It is based on sound, research-based, and behavioral practices, and are easy to use with minimal training.

Safe Excavation, Purdue Ect Team

ECT Fact Sheets

Excavating with a backhoe or similar equipment has the potential risk of hitting an underground utility which could cause serious injuries and expensive damages. An electronic device that provides a real-time warning of the utility lines immediately ahead of the digging tool and provides an easily interpreted, real-time computer readout of the depth, location, and size buried metallic objects. Developed by Dr. Leonhard E. Bernold, it consists of an active metal detector search coil; a signal processing (control) unit; and a PC computer equipped with an analog-to-digital converter interface.

Evaluating And Enhancing The Safety Of Nighttime Construction Projects, Dulcy M. Abraham, Julia Jensen Spadaccini, Beau Braxton Burgess, Lindsay Rae Miller, Vanessa Valentin

JTRP Technical Reports

The increased demand on the current highway system has caused transportation agencies to increase scheduling for nighttime work in order to alleviate daytime work zone congestion, especially during peak traffic hours. Although traffic congestion is reduced, safety in nighttime workzones remains a concern among both transportation agencies and contractors. According to the Federal Highway Administration (FHWA), approximately one-half of the fatalities that occurred in workzones nationwide occurred at night. These work zone statistics have received increased attention among agencies to evaluate planning and safety issues concerning the workers and the general public on nighttime workzones. Four separate, but interrelated research …

Safety Of Intersections On High-Speed Road Segments With Superelevation, Peter T. Savolainen, Andrzej P. Tarko

JTRP Technical Reports

In recent years, the State of Indiana has built a number of intersections where one or both of the roads are located on curves. The AASHTO Policy on Geometric Design of Highways and Streets recommends that in such cases “the alignment should be as straight and the gradient as flat as practical.” This wording, consistent with Part V of the Indiana Design Manual, allows for the design of intersections on curves if other solutions prove to be too expensive. Several of these intersections have raised safety concerns and led to expensive corrective measures. Due to these safety and economic issues, …

Traffic Signals In School Zones, Kevin S. Lee, Darcy M. Bullock

JTRP Technical Reports

Traffic signals are used to control the right of way at intersections. Strict engineering guidelines are published in the Manual on Uniform Traffic Control Devices (MUTCD) that engineers use to determine if a traffic signal is “warranted”. The warrants provide consistent national balance between mobility, safety, efficiency, and costs. However, signalized intersections are often viewed by the general public as safer then unsignalized intersections. This belief is often heightened when there are personal injuries and even higher when children are involved. Parents, city officials, and local interest groups often vigorously request the installation of a traffic signal. After these requests …

Evaluation Of Safety Enforcement On Changing Driver Behavior - Runs On Red (1 Of 2 Volumes), Andrzej P. Tarko, Naredla Lakshmi Reddy

JTRP Technical Reports

Red light running (RLR) is a dangerous act. Approximately 22% of urban crashes at signalized intersections are caused nationwide by RLR. Nearly 1,036 deaths were caused nationwide by RLR in the year 2000. Indiana had no previous research conducted in this area; therefore, this research was aimed at estimating the RLR problem in Indiana. The other objectives of this research included: learning drivers’ opinions on the problem, studying the effectiveness of selected countermeasures, and studying the legal issues related to photo-enforcement. A crash statistics study, telephone survey, and extended monitoring of a selected intersection were the three major approaches chosen …

Evaluation Of Safety Enforcement On Changing Driver Behavior - Runs On Red (2 Of 2 Volumes), Robert C. Zahnke, Maria L. Drake, Jose E. Thomaz

JTRP Technical Reports

Red light running (RLR) is a dangerous act. Approximately 22% of urban crashes at signalized intersections are caused nationwide by RLR. Nearly 1,036 deaths were caused nationwide by RLR in the year 2000. Indiana had no previous research conducted in this area; therefore, this research was aimed at estimating the RLR problem in Indiana. The other objectives of this research included: learning drivers’ opinions on the problem, studying the effectiveness of selected countermeasures, and studying the legal issues related to photo-enforcement. A crash statistics study, telephone survey, and extended monitoring of a selected intersection were the three major approaches chosen …

Improving Efficiency Of Indot Traffic Data Collection Using Gps Devices, Shuo Li, Karen Zhu, Boudewijn H. W. Van Gelder, John Nagle, Carl Tuttle

JTRP Technical Reports

INDOT has utilized many new technologies to reduce travel delay, mitigate traffic congestion, and enhance public and employees’ safety. Many projects are underway, including re-timing of most existing traffic signals and pavement maintenance and rehabilitation. To evaluate signal system performance, prioritize alternatives of improvement, conduct before and after studies and investigate work zone safety, it requires a large amount of traffic data such as travel time, speed and delay. Issues, such as safety, efficiency and cost, may arise associated with the current methods. For the current manual or automatic data collection, it usually requires two operators, a driver and a …

An Analysis Of Speed Limit Policies For Indiana, Nisar M. Khan, Kumares C. Sinha

JTRP Technical Reports

The repeal of the National maximum Speed Limit law in 1995 enabled individual states to set their own speed limits. Speed limits are necessary to ensure mobility while preserving highway safety. It is important that states continually monitor and evaluate existing operating speeds in the context of changing patterns of travel, and changing characteristics of highways, vehicles, drivers, and land-use. Any efforts to review existing speed limits should be accompanied by evaluation of policy impacts such as safety and economic productivity. The goal of this research is to develop a set of speed limit policy guidelines for the state. The …

The Development Of A Speed Monitoring Program For Indiana, Darren L. Jorgenson, Kumares C. Sinha

JTRP Technical Reports

From the passage of the National Maximum Speed Limit (NMSL) of 55 mph in 1974 through its repeal in 1995 speed monitoring programs have been mandated by the federal government. The speed-monitoring program was primarily intended to provide reliable data to be included as a part of the State’s annual certification in order to be approved for Federal Aid highway projects. The repeal of the NMSL in 1995 not only authorized states to set their own speed limits, it also allowed states to develop their own speed monitoring programs. The goal of this research is to provide the framework for …

A Methodology For The Analysis Of Its Impacts On Mobility, Air Quality, And Land Use, Kumares C. Sinha, Srinivas Peeta, Muhammed Amer Sultan, Kamalakar Poonuru, Nadine-Jenelle K. Richards

JTRP Technical Reports

The Indiana Department of Transportation (INDOT) is currently implementing (or has implemented) several components of Intelligent Transportation Systems (ITS). This includes a mini Advanced Traffic Management Systems (ATMS) implemented on a three-mile stretch of the Borman Expressway to evaluate advanced non-intrusive sensor systems and the associated communication infrastructure for the installation of a full-scale ATMS on the 16-mile stretch of the Borman Expressway. Potential specific ITS technologies that are either being implemented or are being considered include pre-trip information, en-route information, variable message signs, and Hoosier Helpers. It is expected that the implementation of various ITS technologies on the Borman …

An Evaluation Of Lane Closure Strategies For Interstate Work Zones, Raktim Pal, Kumares C. Sinha

JTRP Technical Reports

A systematic procedure was developed in the present study that can be used to make a decision regarding the appropriate lane closure strategy at a particular interstate work zone. Four criteria were identified which influence such a decision, namely user travel time and vehicle operating cost, traffic control cost, safety, and contractors’ convenience. The influences of these criteria were aggregated using the Analytic Hierarchy Approach. The procedure developed in the present study is systematic in nature, simple to use and sensitive to the policy adopted by a transportation agency. A computer program, LANECLOSE, was developed which can be readily used …

The Effects Of The All-Red Clearance Interval On Intersection Accident Rates In Indiana, Brian Alan Roper, Jon D. Fricker, Kumares C. Sinha, Robert E. Montgomery

JTRP Technical Reports

The research reported is an evaluation of all-red clearance intervals as the second phase of a project involving traffic signal operation. The first phase of the project dealt with leading versus lagging left turn signal phasing. The study analyzed both the short-term and long-term effects of all-red interval on accident rates in Indiana using accident records for the years 1981 to 1987. The results contradict those of previous studies. Statistical tests indicated that all-red clearance intervals did not cause a reduction in accident rates at the intersections studied in Indiana.