Engineering Commons^™

Learning From Cinara: Exploring The Depths Of Participatory Water Engagement In Cali, Colombia, Zachary T. Strickland

Honors College Theses

Located within the Universidad del Valle in Cali, Colombia, CINARA is an academic institution, comprised of both engineers and social scientists, that has almost three decades of experience regarding participatory approaches to water supply and environmental sanitation. In this paper, I argue that CINARA’s work is important due to its emphasis on meaningful community participation that significantly involves communities in decisions on technical matters that are usually allocated exclusively to “experts.” Furthermore, the valuation of social considerations and non-technical knowledge found amongst CINARA’s engineers stands in distinct contrast to traditional development practices and engineering mindsets. This paper will go on …

State Of Accelerated Bridge Construction (Abc) In The United States, Mike Ofili

Honors College Theses

The purpose of this project is to develop a toolkit for the design and construction of bridges using prefabricated materials primarily to reduce the closure time and on-site construction time of newly constructed bridges or bridges undergoing renovation. The research focuses specifically on short span bridges in Georgia (40,60,80, and 120ft spans).

Areas of primary concern for this project were design, constructability, structural analysis, the use of concrete and steel girders, cost efficiency, and industry surveys. In this particular portion of the study, the surveys proved to be most effective when combined with information obtained existing research as well as …

Improving Energy Efficiency And Environmental Sustainability Of Commercial Insulation, Celine F. Manoosingh, James Mihelcic, Manjriker Gunaratne

Department of Civil Engineering & Construction Faculty Research & Publications

With increasingly stringent energy standards set in place by the Department of Energy, energy efficiency is becoming a paramount concern to manufacturers of appliances. Additionally, the production and disposal of the voluminous amount of polyurethane foam commonly utilized as insulation in refrigeration units poses a significant environmental challenge. In this context, this study investigated an alternative insulation for use in commercial refrigerator/freezer units. A prototype exploring the use of evacuated packets of pyrogenic silica substituting for conventional insulation was assessed. Assessment criteria included experimental comparison of heat transfer characteristics and the energy efficiency of the new insulation as well as …

Color Removal From Pulp Mill Effluent Using Coal Ash Produced From Georgia Power Coal Combustion Plants, Christopher B. Willett

Electronic Theses and Dissertations

Two environmental concerns currently face Georgia: coal fly ash (CFA) waste from coal power plants, and the effluent generated by pulp mills. Pulp mill effluent discolors surface waters into which it is discharged, and has been proven to negatively impact the dissolved oxygen and carbon necessary for aquatic life. The proposed solution is a cost-effective adsorption treatment using an inexpensive but abundantly available waste material: CFA. CFA possesses beneficial properties that allow it to effectively remove contaminants, and is available at significantly reduced cost. The primary research objective was to define treatment parameters that would result in the maximum removal …

Performance Characteristics Of Polyethylene Terephthalate (Pet) Modified Asphalt, Matthew D. Earnest

Electronic Theses and Dissertations

Polyethylene terephthalate (PET) plastic is utilized primarily in food and beverage packaging. Although a portion of waste PET is recycled, the majority of the waste is buried in landfills. Therefore, the use of ground PET particles in asphalt may provide an environmentally friendly solution for the disposal of large quantities of PET waste. This study evaluated the performance of PET as an asphalt modifier with both asphalt binder and asphalt mixture testing. The binder testing was conducted on wet process blends produced with a high shear mixer at PET contents of 5, 10, and 15 percent by weight of the …