Engineering Commons^™

Shrinkage Cracking In Concrete Tilt-Up Construction, Stewart Hooks, Jack Robinson

Architectural Engineering

The purpose of this project is to investigate a particular, undesirable cracking pattern in concrete tilt-up panels that, until now, did not have a known definite cause. The cause of this cracking pattern is hypothesized to be due to shrinkage restraint of the concrete panels. The cracking under investigation occurs at the bottom corners of the Tilt-Up panels, suggesting that the base of the panel is restrained from shrinkage. This project models various components of Tilt-Up Construction that have potential for restraining the panels from shrinking. This project consists of the following main components.

The first aspect of this project …

Quantifying The Impact Of Truck Only Lanes On Vehicular Emissions On A Limited-Access Highway, Edward Chee Tang

Master's Theses

This thesis seeks to estimate CO₂ emissions on a portion of the U.S. 101 highway in San Luis Obispo County before and after construction of a truck only lane on the Cuesta Grade. Towards that aim, the microsimulation software, VISSIM, was used in conjunction with the Environmental Protection Agency’s emissions model, MOVES. The microsimulation model was calibrated and validated against historical and present traffic volumes obtained from Caltrans with good results using several validation measures. It was found that CO₂ emissions did decrease between 1998 and 2012 (pre and post lane addition), but this effect was shown to …