Engineering Commons^™

Computationally Modeling The Human-Structure Interaction Response Of An Occupied Cantilevered Structure, Brennan Smith

Honors Theses

There is a limited understanding of the impact that passive human occupants have on a dynamic structural system, referred to as Human-Structure Interaction (HSI). Cantilevers are naturally prone to excessive vibrations due to their long unsupported spans, and cantilevered structures such as those commonly found in the seating area of a stadium facility or concert hall are designed to support a high density of occupancy.

This study determined that HSI in cantilevered structures can be modeled using a simple two-degree-of-freedom system. The results of the model were validated by data that was collected on a small-scale laboratory structure intentionally designed …

Impacts Of Using Tubular Sections In Open Web Steel Joists, Hollis (Cas) L. Caswell V

Honors Theses

Open web steel joists are lightweight structural trusses used in place of I-beams to support long-span floors and roofs of open space buildings. Their slender geometry makes them highly efficient in resisting flexure, but susceptible to out-of-plane buckling in a failure mode known as lateral-torsional buckling. This failure can be avoided by running lateral bracing between joists called bridging or potentially by using tubular sections to build up the joists rather than angle sections.

It is possible that a joist design using tubular cross-sections could require less bridging and prevent the need to use erection bridging for initial joist construction. …

Study Of The Compressive Strength Of Aluminum Curved Elements, Christine M. Shepherd

Honors Theses

Currently, the Specification for Aluminum Structures (Aluminum Association, 2010) shows thin-walled aluminum plate sections with radii greater than eight inches have a lower compressive strength capacity than a flat plate with the same width and thickness. This inconsistency with intuition, which suggests any degree of folding a plate should increase its elastic buckling strength, inspired this study. A wide range of curvatures are studied—from a nearly flat plate to semi-circular. To quantify the curvature, a single non-dimensional parameter is used to represent all combinations of width, thickness and radius. Using the finite strip method (CU-FSM), elastic local buckling stresses are …

Investigating The Effects Of Various Crowd Characteristics On The Dynamic Properties Of An Occupied Structure, Robert Joseph Firman Iii

Honors Theses

One of the challenges for structural engineers during design is considering how the structure will respond to crowd-induced dynamic loading. It has been shown that human occupants of a structure do not simply add mass to the system when considering the overall dynamic response of the system, but interact with it and may induce changes of the dynamic properties from those of the empty structure. This study presents an investigation into the human-structure interaction based on several crowd characteristics and their effect on the dynamic properties of an empty structure. The dynamic properties including frequency, damping, and mode shapes were …