Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Engineering

Improving Boron For Combustion Applications, Kerri-Lee Annique Chintersingh Aug 2019

Improving Boron For Combustion Applications, Kerri-Lee Annique Chintersingh

Dissertations

Boron has received much attention as a potential additive to explosives and propellants due to its high theoretical gravimetric and volumetric heating values. The challenge, however, is that boron particles tend to agglomerate, have lengthy ignition delays and very low combustion rates. Prior research indicates that boron’s long ignition delays are due to its inhibiting naturally occurring oxide layer, impeding the diffusion of reactants for oxidation. For combustion, current studies report that boron particles have two consecutive stages, but the actual reaction mechanism is poorly understood. Despite many years of relevant research, quantitative combustion data on micron-sized boron particles are …


Reaction Of Titanium Subhydride With Multiple Passivating Gasses, Erik C. Strobert Jr Jan 2019

Reaction Of Titanium Subhydride With Multiple Passivating Gasses, Erik C. Strobert Jr

Chemical and Biological Engineering ETDs

Sandia National Laboratories has used substoichiometric titanium hydride as a pyrotechnic fuel for decades. Production of titanium subhydride requires partial dehydriding of titanium hydride powder and subsequent chemical passivation to render the resultant bare titanium surface nonreactive and the powder non-pyrophoric. Novel passivation techniques, using a gas other than air, have been suggested in the past but have never been investigated. This work examines the reaction kinetics of titanium subhydride with three passivating agents, nitrogen, oxygen, and propane. These passivation experiments took place under isothermal conditions (420 ˚C) with varied dehydriding and passivation time periods. It was found that the …


Catalytic Waste Gasification: Water-Gas Shift & Selectivity Of Oxidation For Polyethylene, Mason J. Lang Jan 2019

Catalytic Waste Gasification: Water-Gas Shift & Selectivity Of Oxidation For Polyethylene, Mason J. Lang

ETD Archive

As landfills approach capacity and take up valuable land space, metropolitan areas have realized the need for waste disposal alternatives. Thus, there has been a widespread use of waste incinerators in Europe and the United States [1]; [2]. Although newer technology has made incinerators more efficient, there is an increasing interest in formulating `greener’ alternatives to incinerators. Gasification converts organic and carbonaceous materials into a combination of gaseous products known as “syngas,” or synthetic gas. This process greatly reduces the amount of hazardous emissions. The syngas produced by gasifiers has a wide range of uses, including their conversion into diesel, …


Elucidation Of The Catalytic Partial Oxidation Of Methane Utilizing The One-Of-A-Kind Catalytic Shock Tube Technique, Robyn E. Smith Jan 2019

Elucidation Of The Catalytic Partial Oxidation Of Methane Utilizing The One-Of-A-Kind Catalytic Shock Tube Technique, Robyn E. Smith

Dissertations and Theses

The mechanism for the catalytic partial oxidation of methane has been debated in scientific literature for over 20 years. This is a seemingly simple reaction producing CO, CO2, H2 and H2O through either partial oxidation followed by complete oxidation or complete oxidation followed by reforming steps. What is happening when the reaction is allowed to occur in an environment absent of transport limitations, absent of temperature gradients and temperature changes, absent of boundary layers must be understood and, until now, has yet to be achieved in one experimental technique.

A novel method using a one …