Engineering Commons^™

An Analytical Model For Rotator Cuff Repairs, A. Aurora, Jorge E. Gatica, A.J. Van Den Bogert, J. A. Mccarron, Kathleen A. Derwin

Chemical & Biomedical Engineering Faculty Publications

Background: Currently, natural and synthetic scaffolds are being explored as augmentation devices for rotator cuff repair. When used in this manner, these devices are believed to offer some degree of load sharing; however, no studies have quantified this effect. Furthermore, the manner in which loads on an augmented rotator cuff repair are distributed among the various components of the repair is not known, nor is the relative biomechanical importance of each component. The objectives of this study are to (1) develop quasi-static analytical models of simplified rotator cuff repairs, (2) validate the models, and (3) predict the degree of …

Bi-Planar Postural Stability Model: Fitting Parameters To Patient Data Automatically, Andrew Michael Sovol

Master's Theses (2009 -)

Studies of children with cerebral palsy (CP) have shown that maintaining control of posture in quiet standing is often difficult. Physical therapy and assistive devices, both with or without surgery, may be employed in an effort to improve postural stability. Assessing the effectiveness of such interventions is important for healthcare providers and their patients. A previously created bi-planar model of posture control has been further developed as a method of assessment. This MATLAB and Simulink model has successfully replicated experimental results for typical adults and children, as well as children with CP across three different test conditions: eyes open, eyes …

Model Omnibus Privacy Statute, Sam S. Han Ph.D.

Sam Han

One of today’s major concerns is how easily digital information can be copied and disseminated. Thus, when one’s private information becomes publicly available in digital format, that information can be readily duplicated and distributed across the globe within seconds. If the disseminated information includes credit card numbers or Social Security numbers, then there is a heightened exposure to identity theft and a host of other privacy-related crimes.

Given the existence of such a digital landmine, laws have been promulgated for various sectors (e.g., financial, healthcare, government, etc.) to protect personally-identifiable information. However, due to differing needs of the various sectors, …

Design, Development And Biomechanical Analysis Of Scaffolds For Augmentation Of Rotator Cuff Repairs, Amit Aurora

ETD Archive

Rotator cuff tears are a source of debilitating pain that commonly affects more than 40 of our aging population. Despite advances in surgical treatment, the failure rate of rotator cuff repairs is as high as 20-90 . Extracellular matrix (ECM) derived scaffolds have recently been investigated as augmentation devices for rotator cuff repairs, but none has yet demonstrated both the appropriate biological and mechanical properties for mitigating re-tears and enhancing healing. This dissertation proposes to engineer the mechanical properties of allograft fascia lata in a manner that will allow its use as an augmentation device for rotator cuff repairs. This …

An Analytical Model For Rotator Cuff Repairs, A. Aurora, Jorge E. Gatica, Antonie J. Van Den Bogert, J. A. Mccarron, Kathleen A. Derwin

Mechanical Engineering Faculty Publications

Background

Currently, natural and synthetic scaffolds are being explored as augmentation devices for rotator cuff repair. When used in this manner, these devices are believed to offer some degree of load sharing; however, no studies have quantified this effect. Furthermore, the manner in which loads on an augmented rotator cuff repair are distributed among the various components of the repair is not known, nor is the relative biomechanical importance of each component. The objectives of this study are to (1) develop quasi-static analytical models of simplified rotator cuff repairs, (2) validate the models, and (3) predict the degree of load …