Engineering Commons^™

Three-Dimensional Stress Analysis Of The Femur With Prosthetic Hip Stem Utilizing Computed Tomography Scans Of The Femur For Geometry And Material Properties, Thomas J. Lavin

Theses

Three-dimensional finite element stress analyses of the femur with prosthesis hip stem were performed for two cases, one male and one female, using ideally bonded cemented titanium prostheses. Computed tomography data files were used to derive the three-dimensional femur geometry and material properties for each cortical bone element. The maximum shear stress (4.7 MPa) in the cement was greater then the maximum tensile stress and occurred at the cement-bone interface. The tensile stresses in the cement were less then the fatigue strength of the cement. The stress patterns were quite similar for the two cases.

A data analysis program was …

A New Concept In Artificial Ligament And Tendons Modeling : Finite Element Analysis, Miroslaw Sokol

Theses

Reconstruction of the Anterior Cruciate Ligament (ACL) has been a major focus in sports medicine for over twenty years. Severe or unrepairable damage of the ACL due to sport injury is a major problem faced by orthopedic surgeons and engineers. To successfully replace or reconstruct an injured ACL, the mechanical properties as well as the dimensional limitation of the material used must be similar to the biological ligaments. Although excessive literature describes experimental investigation on the mechanical property and clinical application of the ligament material, there is no analytical study that describes strains, stresses, and endurance in the bone/ligament/bone complex. …