Engineering Commons^™

Control Mapping Methodology For Tailless Morphing-Wing Aircraft, Zachary S. Montgomery

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Advanced aircraft designs tend to have several control surfaces or devices that affect the flight of the aircraft. It is difficult or even impossible for a pilot to directly control each of these devices and fly the aircraft well. Therefore, a control mapping logic is needed to take typical pilot commands and map them to what the control devices should do to achieve the pilot’s commands. This work presents a methodology for determining this control mapping logic using two different approaches. The first uses a theoretical approach based on lifting-line theory, while the second leverages computational methods. The methodology consists …

Optimal Relative Path Planning For Constrained Stochastic Space Systems, Nathan Bohus Stastny

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Rendezvous and proximity operations for automated spacecraft systems requires advanced path planning techniques that are capable of generating optimal paths. Real-world constraints, such as sensor noise and actuator errors, complicate the planning process. Operations also require flight safety considerations in order to prevent the spacecraft from potentially colliding with the associated companion spacecraft. This work proposes a new, ground-based trajectory planning approach that seeks an optimal trajectory while meeting all mission constraints and accounting for vehicle performance and safety requirements. This approach uses a closed-loop linear covariance simulation of the relative trajectory coupled with a genetic algorithm to determine fuel …

Sonic Boom Loudness Reduction Through Localized Supersonic Aircraft Equivalent-Area Changes, Troy A. Abraham

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The NASA University Leadership Initiative (ULI) titled “Adaptive Aerostructures for Revolutionary Civil Supersonic Transportation” looks to study the feasibility of distributed structural adaptivity on a supersonic aircraft for maintaining acceptable en-route sonic boom loudness during overland flight. The ULI includes a team of industry and university partners that are working together to develop and implement the systems necessary to accomplish this goal.

The Utah State University Aerolab is a member of this ULI team and has been tasked with developing and using low-fidelity supersonic aerodynamic and sonic boom predictions tools to rapidly study the effects of localized geometry changes on …

Numerical Method For Rapid Aerostructural Design And Optimization, Jeffrey D. Taylor, Douglas F. Hunsaker

Mechanical and Aerospace Engineering Student Publications and Presentations

During early phases of wing design, analytic and low-fidelity methods are often used to identify promising design concepts. In many cases, solutions obtained using these methods provide intuition about the design space that is not easily obtained using higher-fidelity methods. This is especially true for aerostructural design. However, many analytic and low-fidelity aerostructural solutions are limited in application to wings with specific planforms and weight distributions. Here, a numerical method for minimizing induced drag with structural constraints is presented that uses approximations that apply to wings with arbitrary planforms and weight distributions. The method is applied to the NASA Ikhana …

Optimization Of A Low Reynold's Number 2-D Inflatable Airfoil Section, Todd A. Johansen

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

A stand-alone genetic algorithm (GA) and an surrogate-based optimization (SBO) combined with a GA were compared for accuracy and performance. Comparisons took place using the Ackley Function and Rastrigin's Function, two functions with multiple local maxima and minima that could cause problems for more traditional optimization methods, such as a gradient-based method. The GA and SBO with GA were applied to the functions through a fortran interface and it was found that the SBO could use the same number of function evaluations as the GA and achieve at least 5 orders of magnitude greater accuracy through the use of surrogate …

Interim Access To The International Space Station, Tyson Karl Smith

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

This thesis evaluates mission scenarios using the existing Evolved Expendable Launch Vehicles for delivering the Crew Exploration Vehicle to the International Space Station. The Space Shuttle is scheduled to retire in the year 2011 and the Ares I is being developed to replace it. With its current schedule, the earliest that the Ares I will become fully operational is 2016. The configurations in this thesis are presented to narrow the gap in which the USA does not have direct access to the International Space Station. They also present "buy down" options for the USA human space operations, if the current …

Optimization Of Torquer Coil Design For Use With The Small Satellite Attitude Control Simulator, David Deloyd Anderson

Undergraduate Honors Capstone Projects

This paper presents a procedure used to optimize the performance of a ferromagnetic core magnetic torquer coil design for use on the Space Dynamics Laboratory (Logan, UT) Small Satellite Attitude Control Simulator. The items of optimization include the primary goal of maximizing the coil 's magnetic moment while reducing power consumption and system mass within given power, mass, and dimensional constraints. The optimization process makes use of several simple equations to determine a few starting points for design, after which an iterative approach based on experimentation is used to produce the final design. It is found that optimal magnetic moment …