Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Engineering
The Next Generation Cubesat: A Modular And Adaptable Cubesat Frame Design, James Dolengewicz, Lucas Whipple, Stephanie Wong
The Next Generation Cubesat: A Modular And Adaptable Cubesat Frame Design, James Dolengewicz, Lucas Whipple, Stephanie Wong
Mechanical Engineering
The goal of this project is to develop an improved next-generation CubeSat structure for Cal Poly’s PolySat program. Notable achievements include significantly increased ease of access, design to optimize payload space, improved machinability, increased modularity and a platform which allows for easy integration of future payloads.
Development Of Cubesat Vibration Testing Capabilities For The Naval Postgraduate School And Cal Poly San Luis Obispo, Marissa Brummitt
Development Of Cubesat Vibration Testing Capabilities For The Naval Postgraduate School And Cal Poly San Luis Obispo, Marissa Brummitt
Master's Theses
The Naval Postgraduate School is currently developing their first CubeSat, the Solar Cell Array Tester CubeSat, or NPS-SCAT. Launching a CubeSat, such as NPS-SCAT, requires environmental testing to ensure not only the success of the mission, but also the safety of other CubeSats housed in the same deployer. This thesis will address the development of CubeSat vibration testing methodology at NPS, including subsystem testing, engineering unit qualification, and flight unit testing. In addition, the new Cal Poly CubeSat Test POD Mk III will be introduced and evaluated based upon comparison with the Poly Picosatellite Orbital Deployer (P-POD). Using examples from …
Non-Explosive Actuator Simulator, Bryan Costanza
Non-Explosive Actuator Simulator, Bryan Costanza
Aerospace Engineering
The CubeSat group at California Polytechnic State University, San Luis Obispo discovered the need for a new piece of ground test equipment. Previous testing of the non-explosive actuator has been very expensive and is not repeatable; two undesirable traits. The analysis of the fuse as well as the design and test of the simulator concept and final article is discussed. The simulator has already seen real use and its entire build and operation cost is much less than the cost of one test of the actual hardware. Performance of the simulator based on burn time and reset time is acceptable …
Cubesat Developers' Workshop 2010, Tracy Owens, Ryan Race
Cubesat Developers' Workshop 2010, Tracy Owens, Ryan Race
Communication Studies
This project is the narrative component of the 7th Annual CubeSat Developers' Workshop 2010 planning process. It reviews the steps and team dynamics over the seven months spent coordinating the conference for the Aerospace Department. It was the first time that students from the Communcation Studies Department were brought in to help with the event, and the gap between the College of Liberal Arts and the College of Engineering was bridged.
Autonomous Satellite Operations For Cubesat Satellites, Jason Lionel Anderson
Autonomous Satellite Operations For Cubesat Satellites, Jason Lionel Anderson
Master's Theses
In the world of educational satellites, student teams manually conduct operations daily, sending commands and collecting downlinked data. Educational satellites typically travel in a Low Earth Orbit allowing line of sight communication for approximately thirty minutes each day. This is manageable for student teams as the required manpower is minimal. The international Global Educational Network for Satellite Operations (GENSO), however, promises satellite contact upwards of sixteen hours per day by connecting earth stations all over the world through the Internet. This dramatic increase in satellite communication time is unreasonable for student teams to conduct manual operations and alternatives must be …