Environmental Design Commons^™

Optimization Of Plastic Waste Integration In Cement Bricks, Yara Salah El-Din El-Metwally

Architectural Engineering

Implementing plastic waste in construction materials is a sustainable disposal method to overcome plastic pollution. The current study aims to optimize the integration of plastic waste in cement bricks regarding their thermomechanical properties in order to develop an eco‑friendly building material. Polyethylene terephthalate (PET) and high‑density polyethylene (HDPE) partially substituted cement with different ratios (0, 2.5, 5, 7.5, 10, 20%). The type that achieved better thermomechanical performance further replaced the other brick components; sand and coarse aggregates to determine the optimum replacement scenario and best design mix. Laboratory experiments have been carried out to measure the compressive strength, indirect tensile …

The Neighborhood As An Energy-Generating Community The Case Of El-Banafseg Residential Neighborhood, East Cairo, Amany G. Micheal Prof., Mona Helmy Dr.

Centre for Advanced Materials

Nowadays, energy consumption is a global challenge. This is due to the shortage of several energy sources, and consequently, to their increasing prices. This paper argues that by using an integrative approach for using various energy harvesting techniques, a typical residential neighborhood can be operated as a self-generator of its needed energy, or part of it.

The paper follows a mixed qualitative, experimental, and numerical simulation approaches to examine the practicality of the paper hypothesis. It uses Space syntax modeling theory (a socio-spatial software) to analyze the pedestrian flow to indicate the potential locations of the kinetic energy harvesting Piezoelectric …

Properties Of Cement Mortar Containing Recycled High-Density Polyethylene (Hdpe), Amany G. Micheal Prof., Esraa Torky, Merna Amir

Centre for Advanced Materials

Millions of tones of plastic waste are generated globally and only less than 10 per cent has been recycled. It is crucial to segregate and circulate plastic waste and repurposing it for countless other uses. There are many ways to repurpose and reuse these discarded plastics. One use that can be examined is the use of plastic as partial sand replacement in mortar. To contribute to this important and valid discourse, the research studies the mechanical and thermal properties of recycled HDPE mortar as an active way of integrating plastic waste into the construction industry to partially eliminate some of …

A Review On Sustainable Disposal Of Plastic Waste By Integration In Construction Materials, Yara S. El-Metwally, Iman El-Mahallawi, Khaled M. Dewidar, Mostafa R. Refaat

Architectural Engineering

Over the last decades, plastic waste (PW) has increased exponentially and has become a serious threat to our planet, aquatic system and human health. Recycling or reusing PW in producing ecofriendly materials is an efficient solution to reduce plastic pollution and to minimize the depletion of raw materials as well. Previous studies have shown promising potentials of using PW in the construction sector, such as binder, aggregate, or substitute of cement and sand in concrete, brick or mortar. Laboratory results indicate that implementing plastic waste as aggregates in cement composites obtains higher thermal resistance and acoustical performance. However, a reduction …