Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Entire DC Network
The Development Of A Finite Element Model For Ballistic Impact Predictions, Richard Allen Perkins
The Development Of A Finite Element Model For Ballistic Impact Predictions, Richard Allen Perkins
Theses and Dissertations
Concrete is a widely used product and is an important application throughout industry due to its inexpensive cost and wide range of applications. This work focuses on understanding the behavior of high strength concrete in high strain rate ballistic impact loading scenarios. A finite element analysis was created with the implementation of the Concrete Damage and Plasticity Model 2 (CDPM2) to represent the material behavior. The model’s parameters were calibrated to existing literature and the results were analyzed by a comparison of the impact velocity to residual velocity and a qualitative assessment of the impact crater. The model captured the …
Additive Manufacturing Of Cork, A Cold Spray Technology, Kimberly Kay Dickey
Additive Manufacturing Of Cork, A Cold Spray Technology, Kimberly Kay Dickey
Theses and Dissertations
Cold Spray Additive Manufacturing is a technology capable of mass manufacturing components with complicated geometry and coating substrates in hard-to-reach areas. In addition, cold spray also has the ability of conducting a green manufacturing process, with zero waste of renewable feed material, and zero gas and chemical emission. This paper investigates solely cold spray as an additive manufacturing technology with cork as the natural material. CFD results were used to predict the physical behavior of air and the cork particles. After unsuccessful coatings, final results showed that when moisture is added, cork is successfully cold sprayed, and agglomeration is experienced. …