Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Entire DC Network
The Wear Behavior Of Cross-Linked Uhmwpe Under Dry And Bovine Calf Serum-Lubricated Conditions
The Wear Behavior Of Cross-Linked Uhmwpe Under Dry And Bovine Calf Serum-Lubricated Conditions
A.S. Md Abdul Haseeb
The present study was performed to investigate the effects of gamma radiation on the wear behavior of unirradiated and irradiated ultra-high-molecular-weight polyethylene (UHMWPE) against Ti-6Al-4V under dry and lubricated conditions at different applied loads. The UHMWPE specimens were exposed directly to nominal doses of 0, 25, 40, 50, and 100 kGy. Scanning electron microscope (SEM) analysis of the worn surface of UHMWPE and Ti-6Al-4V was performed to understand the mechanism of wear involved between the contact surfaces during wear testing. From the wear test results, there were significant differences between the wear of unirradiated UHMWPE and UHMWPE irradiated at 25, …
Tribo-Surface Characteristics Of Al-B4c And Al-Sic Composites Worn Under Different Contact Pressures
Tribo-Surface Characteristics Of Al-B4c And Al-Sic Composites Worn Under Different Contact Pressures
A.S. Md Abdul Haseeb
Tribo-surface characteristics of two aluminium metal matrix composites (Al-MMC) of compositions Al-13 vol%B4C and Al-13 vol%SiC sliding against a commercial phenolic brake pad have been investigated under dry conditions. The wear tests were carried out using a pin-on-disc type apparatus at a linear speed of 1.62 m s-1 under contact pressures ranging from 0.75 to 3.00 MPa. The coefficient of friction was recorded on line. Wear rates were calculated from mass loss measurements. Scanning electron microscope equipped with energy dispersive X-ray spectroscopy was used to examine the tribo-surface. It is found that wear rate of both composites increases with increasing …
Velocity Effects On The Wear, Friction And Tribochemistry Of Aluminum Mmc Sliding Against Phenolic Brake Pad
A.S. Md Abdul Haseeb
Two aluminum metal matrix composites (MMC) reinforced with 13 vol.% of SiC or B4C particles were made by stir casting followed by hot extrusion. Effects of sliding velocity on the wear, friction and tribochemistry of the worn surfaces of both composites sliding against a commercial phenolic brake pad have been investigated under dry condition. The wear tests were carried out using a pin-on-disc type apparatus at two linear sliding speeds: 1.62 and 4.17 m s-1 under a constant contact pressure of 0.75 MPa for a sliding distance of 5832 m. The coefficient of friction was recorded and wear rate of …
Study Of The Wear Behaviour Of Al-4.5% Cu-3.4% Fe In Situ Composite: Effect Of Thermal And Mechanical Processing
A.S. Md Abdul Haseeb
Wear behaviour of as-cast and heat-treated spheroidal graphite (SG) cast iron has been studied under dry sliding conditions using a pin-on-disc type apparatus. Wear tests were carried out at a linear sliding speed of 0.88 m s -1, under a constant load of 1.5 kg. All tests were performed in ambient air at room temperature. Extent of wear damage and wear mechanisms were investigated by means of weight loss measurement, optical microscopy, microhardness measurement and X-ray diffractometry on wear debris. The wear rate measured after 9500 m of sliding is found to be about three times higher in the as-cast …