Open Access. Powered by Scholars. Published by Universities.®
- Institution
Articles 1 - 4 of 4
Full-Text Articles in Entire DC Network
Experimental And Numerical Investigation Of Heat Transfer In Cnt Nanofluids
Experimental And Numerical Investigation Of Heat Transfer In Cnt Nanofluids
Faculty of Engineering University of Malaya
Nanofluids with their enhanced thermal conductivity are believed to be a promising coolant in heat transfer applications. In this study, carbon nanotube (CNT) nanofluids of 0.01wt%, stabilised by 1.0wt% gum arabic were used as a cooling liquid in a concentric tube laminar flow heat exchanger. The flow rate of cold fluid varied from 10 to 50g/s. Both experimental and numerical simulations were carried out to determine the heat transfer enhancement using CNT nanofluids. Computational fluid dynamics (CFD) simulations were carried out using Fluent v 6.3 by assuming single-phase approximation. Thermal conductivity, density and rheology of the nanofluid were also measured …
Effects Of Carbon Black And The Presence Of Static Mechanical Strain On The Swelling Of Elastomers In Solvent
Faculty of Engineering University of Malaya
The effect of carbon black on the mechanical properties of elastomers is of great interest, because the filler is one of principal ingredients for the manufacturing of rubber products. While fillers can be used to enhance the properties of elastomers, including stress-free swelling resistance in solvent, it is widely known that the introduction of fillers yields significant inelastic responses of elastomers under cyclic mechanical loading, such as stress-softening, hysteresis and permanent set. When a filled elastomer is under mechanical deformation, the filler acts as a strain amplifier in the rubber matrix. Since the matrix local strain has a profound effect …
Effect Of Tool Rotational Speed On Force Generation, Microstructure And Mechanical Properties Of Friction Stir Welded Al-Mg-Cr-Mn (Aa 5052-O) Alloy
Faculty of Engineering University of Malaya
Friction stir welding (FSW) between 3 mm thick AA 5052-O aluminum alloy plates was investigated in the present study. Different welded specimens were produced by employing a constant tool traverse speed of 120 mm/min and by varying rotating speeds from 800 to 3000 rpm. The welded joints were characterized by its appearances, microstructural and mechanical properties at room temperature. The measurement of different forces acted on the tool during the FSW of AA 5052-O plates provided a significant insight to determine the quality of the welded joints. From the appearances of the welded joints it was evident that, except the …
Influences Of Flame-Retardant Fillers On Fire Protection And Mechanical Properties Of Intumescent Coatings
Faculty of Engineering University of Malaya
A combination of acrylic binder and flame-retardant ingredients was used to synthesize the solvent-borne intumescent coatings designed for steel substrates. The influences of individual and various combinations of flame-retardant fillers on the fire protection and mechanical properties of the coatings were characterized by using Bunsen burner, thermogravimetric analysis, limiting oxygen index, field emission scanning electron microscopy, freeze thaw cycles, static immersion and pull-off type equipment. It was found that the combination of aluminium hydroxide (Al(OH)(3)) and titanium dioxide (TiO2) has significantly improved the fire protection, thermal stability and water resistance of the coating. This formulation had an LOI value of …