Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 2 of 2
Full-Text Articles in Dentistry
Current Status Of Direct Pulp-Capping Materials For Permanent Teeth, Takashi Komabayashi, Qiang Zhu, Robert Eberhart, Yohji Imai
Current Status Of Direct Pulp-Capping Materials For Permanent Teeth, Takashi Komabayashi, Qiang Zhu, Robert Eberhart, Yohji Imai
Dental Medicine Faculty Publications
Direct pulp-capping is a method for treating exposed vital pulp with dental material to facilitate the formation of reparative dentin and to maintain vital pulp. Two types of pulp-capping materials, calcium hydroxide and mineral trioxide aggregate, have been most commonly used in clinics, and an adhesive resin has been considered a promising capping material. However, until now, there has been no comprehensive review of these materials. Therefore, in this paper, the composition, working mechanisms and clinical outcome of these types of pulp-capping materials are reviewed.
Sustained Release Of Calcium Hydroxide From Poly(Dl-Lactide-Co-Glycolide) Acid Microspheres For Apexification, Bernardino Isaac Cerda-Cristerna, Alejandro Breceda-Leija, Verónica Méndez-González, Daniel Chavarría-Bolaños, Héctor Flores-Reyes, Arturo Garrocho-Rangel, Takashi Komabayashi, Aniket S. Wadajkar, Amaury J. Pozos-Guillén
Sustained Release Of Calcium Hydroxide From Poly(Dl-Lactide-Co-Glycolide) Acid Microspheres For Apexification, Bernardino Isaac Cerda-Cristerna, Alejandro Breceda-Leija, Verónica Méndez-González, Daniel Chavarría-Bolaños, Héctor Flores-Reyes, Arturo Garrocho-Rangel, Takashi Komabayashi, Aniket S. Wadajkar, Amaury J. Pozos-Guillén
Dental Medicine Faculty Publications
Calcium hydroxide (Ca(OH)2) loaded poly(DL-lactide-co-glycolide) acid (PLGA) microspheres (MS) might be employed for apexification requiring a sustained release of Ca++. The aim of this study was to formulate and characterize Ca(OH)2-PLGA-MS. The Ca(OH)2-loaded MS were prepared by either oil-in-water (O/W) or water-in-oil/in-water (W/O/W) emulsion solvent evaporation technique. MS produced by the O/W technique exhibited a larger diameter (18.63 ± 7.23 μm) than the MS produced by the W/O/W technique (15.25 ± 7.37 μm) (Mann Whitney U test P < 0.001). The Ca(OH)2 encapsulation efficiency and Ca++ release were calculated from data obtained by absorption techniques. Ca++ release profile was evaluated for 30 days. The percentage of encapsulation efficiency of the O/W-produced MS was higher (24%) than the corresponding percentage of the W/O/W-produced MS (11%). O/W- and W/O/W-produced MS released slower and lower Ca++ than a control Ca(OH)2 paste with polyethylene glycol 400 (ANOVA 1 way, Tukey HSD P < 0.01). O/W-produced MS released higher Ca++ than W/O/W-produced MS (statistically significant differences with t-Student test). We concluded that Ca(OH)2-PLGA-MS were successfully formulated; the technique of formulation influenced on the size, encapsulation efficiency and release profile. The MS were better sustained release system than the Ca(OH)2 paste.