Open Access. Powered by Scholars. Published by Universities.®
- Keyword
Articles 1 - 2 of 2
Full-Text Articles in Medicine and Health Sciences
Muscle Synergy During A Single Leg Standing Test In Ambulatory Children With Cerebral Palsy, Brennan L. Smith
Muscle Synergy During A Single Leg Standing Test In Ambulatory Children With Cerebral Palsy, Brennan L. Smith
Theses and Dissertations--Kinesiology and Health Promotion
INTRODUCTION: Cerebral Palsy (CP) is a sensorimotor disorder characterized by dysfunctional motor coordination, balance problems, and loss of selective motor control. Motor coordination exhibited as co-contraction, has been subjectively quantified using gait analysis, but recent studies have begun to objectively analyze the amount of co-contraction by collecting electromyography (EMG) data. Center of pressure excursion (COPE) measurements collected during a single leg standing test (SLST) have shown to be more valid measurements of balance in populations with motor disabilities than a SLST alone. A recent study has correlated increased COPE velocity with a lower fall risk as determined by reported fall …
Design And Analysis Of A 3d-Printed, Thermoplastic Elastomer (Tpe) Spring Element For Use In Corrective Hand Orthotics, Kevin Thomas Richardson
Design And Analysis Of A 3d-Printed, Thermoplastic Elastomer (Tpe) Spring Element For Use In Corrective Hand Orthotics, Kevin Thomas Richardson
Theses and Dissertations--Mechanical Engineering
This thesis proposes an algorithm that determine the geometry of 3D-printed, custom-designed spring element bands made of thermoplastic elastomer (TPE) for use in a wearable orthotic device to aid in the physical therapy of a human hand exhibiting spasticity after stroke. Each finger of the hand is modeled as a mechanical system consisting of a triple-rod pendulum with nonlinear stiffness at each joint and forces applied at the attachment point of each flexor muscle. The system is assumed quasi-static, which leads to a torque balance between the flexor tendons in the hand, joint stiffness and the design force applied to …