Open Access. Powered by Scholars. Published by Universities.®

Medicine and Health Sciences Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Medicine and Health Sciences

Effects Of Flash-Free Technique On Plaque Retention, White Spot Lesions, And Bracket Failure: A Randomized Clinical Trial, Payam Ishani Afousi Dec 2016

Effects Of Flash-Free Technique On Plaque Retention, White Spot Lesions, And Bracket Failure: A Randomized Clinical Trial, Payam Ishani Afousi

Theses & Dissertations

A side effect of orthodontic treatment is the development of white spot lesions (WSLs). This thesis attempted to evaluate the effects of the use of APC™ Flash-Free (FF) and conventional adhesives in bonding of orthodontic brackets on plaque formation and retention, WSL development, and bracket failure in-vivo. This was accomplished by collecting plaque samples from around orthodontic appliances and analyzing them using ATP-driven bioluminescence; scanning enamel surfaces using the Canary System™ to evaluate WSL development, and counting the number of spontaneous debonding of brackets of the 4 maxillary incisors in the first 6 months of treatment. It was found …


Color Stability, Physical Properties And Antifungal Effects Of Zro2 And Tio2 Nanoparticle Additions To Pigmented Polydimethylsiloxanes, Mazen Alkahtany May 2016

Color Stability, Physical Properties And Antifungal Effects Of Zro2 And Tio2 Nanoparticle Additions To Pigmented Polydimethylsiloxanes, Mazen Alkahtany

Theses & Dissertations

Introduction: Color changes, physical degradation and fungal infections are potential challenges to the longevity of polydimethylsiloxane (PDMS) elastomers. The purpose of this study was to evaluate potential improvements in color change, physical properties and anti fungal properties of PDMS loaded with TiO2 and ZrO2 nanoparticles.

Methods: 1% weight of 40 nm or 200 nm diameter TiO2 or ZrO2 nanoparticles were mixed into PDMS with 2% functional intrinsic yellow pigment and polymerized. Control materials contained 13% weight 200 nm silica. Samples were exposed to either 3000 hours of UVB radiation (200 μW/cm2) or darkness. Color parameters L*a*b* and ΔE*, ultimate tensile …