Engineering Commons^™

Vhf Transmitter Development For Wildlife Tracking, Bryan Westra

Masters Theses

Wildlife biologists often use collars with VHF transmitters to gather wildlife data. The purpose of this project is to determine the best approach to designing a wildlife tracking VHF transmitter on a Printed Circuit Board (PCB). A variety of frequency generation methods were considered for the transmitter, including transistor-based crystal oscillators and chip based solutions from the chip manufacturers Analog Devices and Silicon Labs. Prototypes of the feasible options were built and evaluated for cost, power consumption, efficiency, size, frequency range, signal bandwidth, and frequency stability. It was found that the Silicon Labs Si4010 chip was the best solution based …

Radiation Immunity In Cable Harnesses And Differential P/N Skew In Pcb, David Nozadze

Masters Theses

"We develop an efficient method to model RF immunity of multiwire cable harnesses and study differential P/N skew effects on channels, channel performance and specifically on the eye diagrams at the SerDes receiver.

External radiation can induce unwanted signals in transmission lines. For example, external radiation from an antenna induces common-mode currents on the outer surface of cable shields. This common-mode signal makes its way through the shied due to its imperfections, inducing the inner common mode. When twisted pairs inside the cable are not balanced, inner common mode is in turn converted to the differential mode, which might compromise …