Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

PDF

Faculty Publications

Series

2003

Electrodeposition

Articles 1 - 2 of 2

Full-Text Articles in Engineering

A Novel Electrodeposition Process For Plating Zn-Ni-Cd Alloys, Hansung Kim, Branko N. Popov, Ken S. Chen Jan 2003

A Novel Electrodeposition Process For Plating Zn-Ni-Cd Alloys, Hansung Kim, Branko N. Popov, Ken S. Chen

Faculty Publications

Zn-Ni-Cd alloy was electrodeposited from an alkaline electrolytic bath under potentiostatic conditions. Bath analyses using a pH concentration diagram reveal that addition of a complexing agent is essential to maintain the bath stability. Introduction of a low concentration of CdSO4 reduces the anomalous nature of the Zn-Ni deposit. Deposits obtained from the electrolytic bath which contains 60 g/L of ZnSO4·7H2O, 40 g/L of NiSO4·6H2O, 1 g/L of CdSO4, and 80 g/L of (NH4)2SO4 in the presence of additives and ammonium hydroxide at pH 9.3 …


Development Of A Novel Electrochemical Method To Deposit High Corrosion Resistant Silicate Layers On Metal Substrates, Basker Veeraraghavan, Bala Haran, Dragan Slavkov, Swaminatha Prabhu, Branko N. Popov, Bob Heimann Jan 2003

Development Of A Novel Electrochemical Method To Deposit High Corrosion Resistant Silicate Layers On Metal Substrates, Basker Veeraraghavan, Bala Haran, Dragan Slavkov, Swaminatha Prabhu, Branko N. Popov, Bob Heimann

Faculty Publications

A novel method for electrodepositing silicates on metallic substrates from aqueous solutions has been developed. The technique is demonstrated by forming a passive film on galvanized steel. The silicate layer was deposited cathodically from a bath containing PQ Corporation N sodium silicate solution (3.22 weight ratio sodium silicate, 37.5% solution in water). A post-treatment drying process increased the Si content in the coating and improved the corrosion characteristics of the silicate layer. Deposition parameters like bath concentration and temperature have been optimized using corrosion characteristics and surface morphology of the final coating. Finally, stability studies show that the silicate coatings …