Science and Technology Studies Commons^™

3d Scan Data For Caddo Ceramic Vessels From The George C. Davis Site (41ce19), Robert Z. Selden Jr.

CRHR: Archaeology

On June 8, 2015, the intact and reconstructed vessels from the George C. Davis site (41CE19) were scanned (3D) in advance of an analysis of 3D geometric morphometrics. These data were collected using a Creaform GoSCAN50 running VXElements via the scanner direct control function in Geomagic Design X. All data associated with this project are available in Zenodo under a Creative Commons Attribution license, where they can be downloaded for use in additional projects. These data have the capacity to augment numerous research designs in the digital humanities and ceramic studies, as well as a wide range of comparative research …

Documentation Of Caddo Ceramic Vessels In The Texas Parks And Wildlife Department Holdings From Goliad State Park, Timothy K. Perttula, Robert Z. Selden Jr.

CRHR Research Reports

On February 6, 2015, three Caddo vessels from an unknown site or sites were documented at the Texas Parks and Wildlife Department’s Archeology Laboratory, where the standard suite of metadata was collected, accompanied by photographs and 3D models of each vessel. While the donor of these vessels remains unknown, stylistic and technological attributes can be used to posit the potential region of origin.

There are three 3D models included in this report of NAGPRA documentation. To manipulate, measure, and otherwise quantify variability in the models, this document must be downloaded, then opened in either Adobe Acrobat or Adobe Reader. These …

3d Scan Data Of Caddo Burial Vessels From The Mcspadden Site Near Frankston, Texas, Robert Z. Selden Jr.

CRHR Research Reports

In the spring of 2013, three Caddo burial vessels from an unrecorded site near Frankston, Texas were documented at the McSpadden residence in College Station, Texas. All three vessels are intact and are not reconstructed. Scan data was collected using a ZScanner 700CX running VXElements 2.0 via the scanner direct control function in Geomagic Design X. Post-processing of these data occurred in Design X, and quality control for missing data leveraged both Design X and Verify. These data will be used in a study aimed at the 3D geometric morphometric analysis of Caddo vessels. In addition to the study of …