Defense and Security Studies Commons^™

Ddasaccident814, Hd-Aid

Global CWD Repository

The accident occurred in one of the remote Mine Field (MF) tasks (HZTJ-335-MM10) located in TAB region of Tajikistan, Shamsiddin Shohin district: 30 km from nearest hospital, 60 min of driving by narrow and bad condition restricted border zone road, and was caused due to hand excavation tool (demining trowel) penetration into the liquid explosive container of an AP blast mine type PFM-1. Penetration, fortunately, did not provoke any detonation, but resulted in rupturing the plastic mine casing and spraying of the liquid explosive charge contents into the eyes, mouth and facial area of the deminer operating the demining tool.

Ddasaccident825, Hd-Aid

Global CWD Repository

On the 29th of November 2016 at [International demining organization] task NDO-235 S, an uncontrolled detonation of a GYATA 64 AP mine occurred while [International demining organization] MTT 1 deminer [the Victim] was working in his lane (11 minutes into his second shift) and led to an injury.

The injuries sustained by [the Victim] resulted in the amputation of his left pinky finger, and severe wound in his left index finger, burns in his left wrist, severe wound in his right forearm and some minor wounds and scratches in the front area of his legs.

Based on all available evidences, …

Ddasaccident807, Hd-Aid

Global CWD Repository

At 10:50am TL announced a regular ten minutes break and deminers took their rest close to the base line of the MF. TS took one of the deminer’s metal detector MineLab F3S and entered 3m deep into uncleared area. He started investigation of subsurface metal signals. TS called TL [Name removed] who was sitting in the safe area in proximity of 15m from TS. When TL took his first step towards TS the explosion occurred. As a result of explosion force, TS’s helmet hit TL’s chest and TL fell down to the ground. When TL stood up he saw the …

Ddasaccident806, Hd-Aid

Global CWD Repository

The explosion occurred in the mined area of the Khoshima Novobod Qabodiyon community. As a result of a PMN explosion a deminer received light injuries This de-miner had been sent by [Demining group] for the mine clearance operation according to the task.

Ddasaccident804, Hd-Aid

Global CWD Repository

Deminer investigated the mound by detector, than removed it up to the original surface of the ground. During checking the hard surface by detector the deminer detected a subsurface signal. During the excavation of the second layer the sudden detonation of mine occurred.

Ddasaccident823, Hd-Aid

Global CWD Repository

The Board of Investigation report records that this was a BAC accident involving an “uncontrolled detonation” of a submunition. It was investigated at Ayta el Jabel on 7th May 2014 by the Chief of QA from the Regional Mine Action Centre (N).

On the 7th of May 2014 at [International demining NGO] task CBU-764, an uncontrolled detonation of a BLU-63 sub-munition occurred while [International demining NGO] searcher [the Victim] was removing stones in his lane and led to his death. [The Victim] sustained severe injuries from fragmentations of the detonated BLU-63 in the whole face, amputation of the five fingers …

Ddasaccident798, Hd-Aid

Global CWD Repository

During the sampling of the cleared area the TA continued prodding (each 2 centimetres) into the clear and unclear area as an overlap and excavating any resistance on the prodder in the very loose sand. Without any prodding force a detonation took place causing 1 PMN AP to explode.

Ddasaccident731, Hd-Aid

Global CWD Repository

While the deminer working in the Ren. Belt (B) clearing the AP M14 in cluster 8 last section home side dir 9 o’clock a pressure applied on the top of the AP mine which caused the mine blast and it’s considered as an individual mistake.

Ddasaccident746, Hd-Aid

Global CWD Repository

The deminer was working in SML D which contains M14 AP mines, he indicated the location of the mine then used the light rake then excavated using the heavy rake, during the excavation for the mine using the heavy rake the deminer accidentally caused a pressure on the AP mine pressure plate which caused the detonation.

Ddasaccident720, Hd-Aid

Global CWD Repository

The deminer was working in IOE containing M14 AP mines in Section 3 in Sabha 11, he used the MD to indicate the location of the mine then used the light rake then excavated using the heavy rake, during the excavation for the mine using the heavy rake, the deminer hit accidentally the AP mine on the top which detonated the mine.

Ddasaccident742, Hd-Aid

Global CWD Repository

According to external investigation report, the accident happened during the prodding operation on a detected signal. According to the witness statements the deminer may had been failed to pinpoint the signal or he may had started prodding directly from the top of it and not maintained the right angle of the prodder. The density of rocks there and hardness of the ground required more attention to be paid by deminer during the operation, but it seems that he was working in hurry without considering standard operating procedures to be applied during signal investigation. The record of QA shows that this …

Ddasaccident590, Hd-Aid

Global CWD Repository

On the 8th of December 2010 a demining accident occurred at site NR-880 near the town of El Maria within the Kassala locality in which a deminer sustained traumatic injuries whilst conducting prodder drills and thus initiating a No4 AP mine. Immediate medical care was rendered to the injured deminer who was maintained in a stable condition.

Ddasaccident740, Hd-Aid

Global CWD Repository

On the 13th Dec 2010 at 10:37, the deminer [Victim No.1] was operating in his clearance lane excavating a detected signal, his prodder touched on a subsurface tripwire of POMZ mine which caused it to explode. According to the investigation report the signal was not pinpointed correctly and the de-miner has used pick in contrary to set procedure, during the excavation, he pulled the subsurface tripwire connected with POMZ mine. The accident resulted in superficial injuries to deminer’s hands, left thigh and left side of abdomen.

Ddasaccident801, Hd-Aid

Global CWD Repository

The deminer was busy with clearance in M/F No3, Lane No1 and had an indication from his F3 mine detector. He then carried out the prodder drill investigating the signal and the mine detonated. It is unclear at present why the No4 A/P mine detonated. It appears that the mine was slightly outside the 10cm overlap of the basestick but this could not be confirmed due to the movement of the marking rocks and base stick when the blast occurred.

Ddasaccident714, Hd-Aid

Global CWD Repository

I remember on the 25th of Oct. 2010 on the first part of work I cleared 3 AP mines from the first cluster as all the AT mines are cleared from the belt, then I headed to the next cluster following the team leader orders and started removing a 12 o’clock mine, when I was near its suggested location after making visual check and cleared the grass around it using the light rake I were no injuries thanks god, then the team leader came with deminer {name removed] and checked me and evacuated me walking to the ambulance which was …

Ddasaccident808, Hd-Aid

Global CWD Repository

At 08:16 the Head of the Operational Management of [Demining group] Mr.[Name removed] reported to the radio-operator [Name removed] about mine explosion in the mine field No. 2 - Arjamazor village Kevron. A deminer of the group #4 [the Victim] was injured from PMN-2 and ML-7. Their characteristics are indicated in below table.

Ddasaccident753, Hd-Aid

Global CWD Repository

On the 7th Oct 2010 at 08:40, the deminer [the Victim] initiated a PMN anti-personnel mine with a pick outside of his clearance lane which caused the accident. The section leader was around 60 meters away busy in taking coordinates of a found mine with GPS and the team leader was busy in admin area updating the attendance sheet. The deminer was busy in the minefield without being observed by the command group for almost 15 minutes during the operation while the accident happened.

Ddasaccident655, Hd-Aid

Global CWD Repository

Deminer was approaching 9 O’clock M35 AP mine on one of the main mine belt clusters, after she removed the AT mine she located the M35 mine and started to excavate beside the mine, accidently she hit the mine by the heavy rake and caused the blast

Ddasaccident759, Hd-Aid

Global CWD Repository

On 06 Sep 2010, when Mr. [the Victim] was working in his clearance lane and excavated a detected signal, during the excavation drill his excavation tool touched the mine and caused it to go off. According to investigation report the cause of the accident was the wrong excavation technique, as he started excavation drill close to the pinpointing target. He had gone down and did not expand the trench to allow entry from the side, which caused to stroke his excavation tool on the top of the mine. Due to the injuries sustained on his eyes, it seems that the …

Ddasaccident729, Hd-Aid

Global CWD Repository

On 17 August 2010 while [the Victim] was working in his clearance lane, his excavation tool touched a mine and caused it to go off. According to the investigation report and the injuries sustained by victim deminer, it seems that the de-miner has excavated a detected signal carelessly and in contrary to their SOP. It means signal was not pinpointed correctly and the de-miner had used the excavation tool directly on the top of mine, so the accident happened. Unfortunately the de-miner did not put his PPE on, therefore, he got severe injuries on his eyes, whole face, neck, chest, …

Ddasaccident730, Hd-Aid

Global CWD Repository

On 17 August 2010 Mr. [the Victim] the deminer was working in his clearance lane excavating a detected signal, his excavation tool touched a mine and caused it to explode. According to the investigation report the signal was not pinpointed correctly and the de-miner has used his bayonet directly on the top of anti-personnel mine, so the accident happened. Unfortunately the victim deminer was not fully dressed with PPE, so he got severe injuries on his eyes, whole face and finger of his left hand.

Ddasaccident658, Hd-Aid

Global CWD Repository

On 15 August 2010 while [the Victim] deminer was busy in his clearance lane excavating a detected signal, his excavation tool touched a mine and caused it to explode. According to the investigation report the signal was not pinpointed correctly and the deminer has used his excavation tool directly on the top of anti-personnel mine and the accident happened. Fortunately the victim deminer was fully dressed with PPE, so he got a superficial injury between the thumb & index finger of his right hand.

Ddasaccident659, Hd-Aid

Global CWD Repository

The incident happened while the deminer trying to investigate a signal using the heavy RAKE. The deminer was close to the mine and the distance was less than the RAKE handle 2.2 m that the area very sloppy (water course) and the deminer was looking for the missing mines.

Ddasaccident644, Hd-Aid

Global CWD Repository

The incident happened due an individual mistake while the deminer investigating an indicated signal by the metal detector in the predicted site of the AP mine within the cluster. The deminer mis approach the mine and hit it from the top which caused the heavy RAKE to press the pressure plate and activated the mine about 2m from the deminer (the length of the RAKE handle). This the second incident with the same deminer and the same scenario.

Ddasaccident750, Hd-Aid

Global CWD Repository

On 10 July 2010 at 09:15 AM Mr. [the Victim] the de-miner of mentioned team was working in his clearance lane, excavating a detected signal, his pick touched on the top of a PMN 2 anti-personnel mine and caused it to go off. According to the investigation report the de-miner has used the pickaxe to investigate the signal instead of the bayonet and it seems as he used the pick directly on the top of signal, so caused the accident. Luckily the deminer was fully dressed with PPE, so he got a superficial injury on hand. Then the victim de-miner …

Ddasaccident767, Hd-Aid

Global CWD Repository

The team started operations on 05:30 at the morning, everyone received briefing from the team leader. MU-07 was implementing a regime of 30 minutes work and 10 minutes break in this area, as it is a difficult and steep sloping task. It was 08:15 that the deminer [Victim No.2] detected a signal in his clearance lane and then identified that it was a POMZ mine after discovering a part of it. He called his team leader that he has found a POMZ mine and partially discovered it. During the investigation, he initiated the mine, causing it to detonate and the …

Ddasaccident718, Hd-Aid

Global CWD Repository

The accident occurred on 22 June 2010, 09:30 AM in clearance lane of [the Victim], located in a steep sloping area within the MF. He was busy in full excavation there, suddenly some stones and soil slipped down in front of him and caused a PMN2 mine to go off. The ground where [the Victim] was working was of a loose and sliding nature, so it slipped down and directly hit the mine and caused the accident. So this was an unpreventable accident in nature, but as it seems from the location and severity of injuries, the visor was not …

Ddasaccident676, Hd-Aid

Global CWD Repository

While the deminer try to investigate a signal indicated by the metal detector in an expected site of an AP M14 mine, the deminer didn’t approach the signal in the proper procedure and hit the mine with the heavy Rake on the pressure plate which activated the mine and caused the blast 200 away from the deminer

Ddasaccident594, Hd-Aid

Global CWD Repository

On 04 May 2010 at 08:45 am while [the Victim] the de-miner was excavating a detected signal in his clearance lane, his bayonet hit top of an anti-personnel PMN mine and caused it to go off. According to the investigation report, it seems that the de-miner started excavation directly from the pinpointed spot with his bayonet and caused the explosion and accident. Unfortunately improper use of PPE caused catastrophic injuries to the face and eyes of the victim deminer. He has lost his right eye, traumatic amputation of right-hand fingers and sustained some superficial injures on different parts of his …

Ddasaccident595, Hd-Aid

Global CWD Repository

On 9th April 2010 at 10:27 while [the Victim] was working in his clearance lane, busy in excavation drill, the accident happened and caused severe injuries to his right hand (traumatic amputation) and some minor injuries to his neck and nose. His visor was broken down and separated from headband. As per the investigation report, the deminer has breached the SOPs as dug directly down on top of the mine. It is also possible that he tried to work in a bit hurry to increase the progress. As he was fully dressed with PPE, therefore, remained save from other severe …