Defense and Security Studies Commons^™

Ddasaccident829, Hd-Aid

Global CWD Repository

On the 6th of February 2018 at [International demining organization] task MF-1115, an uncontrolled detonation of 2 No 4A AP mines occurred while [International demining organization] MAT 2 Site Supervisor [the Victim] was preparing for demolitions.

The injuries sustained by [the Victim] resulted in: Amputation for both hands at forearm level, loss of left eye and some damage to the right eye without knowing if can see with it or not, fractures in the jaw, swelling and small bleeding in the brain, severe wounds and fractures in the face, and partial lung rupture caused by blast-wave but no fragmentations, shrapnel …

Ddasaccident814, Hd-Aid

Global CWD Repository

The accident occurred in one of the remote Mine Field (MF) tasks (HZTJ-335-MM10) located in TAB region of Tajikistan, Shamsiddin Shohin district: 30 km from nearest hospital, 60 min of driving by narrow and bad condition restricted border zone road, and was caused due to hand excavation tool (demining trowel) penetration into the liquid explosive container of an AP blast mine type PFM-1. Penetration, fortunately, did not provoke any detonation, but resulted in rupturing the plastic mine casing and spraying of the liquid explosive charge contents into the eyes, mouth and facial area of the deminer operating the demining tool.

Ddasaccident817, Hd-Aid

Global CWD Repository

A deminer from the NGO [International demining organisation] was killed in Pailin province on Friday after detonating a mine while attempting to clear an area in the former Khmer Rouge stronghold.

One employee of the British demining organisation [name removed] died and another was injured after an antipersonnel mine exploded while they were working in Pailin province.

The anti-personnel blast mine in this accident was reported as having been a GYATA-64 and as having been a PMN-2. The source reporting it as a PMN-2 was the Cambodian Mine Action Centre so that identification is accepted, especially as the mine is …

Ddasaccident825, Hd-Aid

Global CWD Repository

On the 29th of November 2016 at [International demining organization] task NDO-235 S, an uncontrolled detonation of a GYATA 64 AP mine occurred while [International demining organization] MTT 1 deminer [the Victim] was working in his lane (11 minutes into his second shift) and led to an injury.

The injuries sustained by [the Victim] resulted in the amputation of his left pinky finger, and severe wound in his left index finger, burns in his left wrist, severe wound in his right forearm and some minor wounds and scratches in the front area of his legs.

Based on all available evidences, …

Ddasaccident807, Hd-Aid

Global CWD Repository

At 10:50am TL announced a regular ten minutes break and deminers took their rest close to the base line of the MF. TS took one of the deminer’s metal detector MineLab F3S and entered 3m deep into uncleared area. He started investigation of subsurface metal signals. TS called TL [Name removed] who was sitting in the safe area in proximity of 15m from TS. When TL took his first step towards TS the explosion occurred. As a result of explosion force, TS’s helmet hit TL’s chest and TL fell down to the ground. When TL stood up he saw the …

Ddasaccident806, Hd-Aid

Global CWD Repository

The explosion occurred in the mined area of the Khoshima Novobod Qabodiyon community. As a result of a PMN explosion a deminer received light injuries This de-miner had been sent by [Demining group] for the mine clearance operation according to the task.

Ddasaccident804, Hd-Aid

Global CWD Repository

Deminer investigated the mound by detector, than removed it up to the original surface of the ground. During checking the hard surface by detector the deminer detected a subsurface signal. During the excavation of the second layer the sudden detonation of mine occurred.

Ddasaccident811, Hd-Aid

Global CWD Repository

The accident occurred outside of cleared and marked area, in the bank of Panj River, just 3m away from water line. TL left his helmet and map case in the cleared area (found later in systematic technical survey lane), stepped over the marking and proceeded passing through the uncleared dangerous area towards to river. The foot prints on the ground are clearly visible where TL stepped over the marking. The distance (straight line) between this place and place of explosion is 77m.

Ddasaccident805, Hd-Aid

Global CWD Repository

Whilst the Team leader was at the CP reporting the find, the three deminers – [Victim No.1], [Victim No.2] and [Victim No.3] - moved from their lanes to view the PMN. It was at this stage that [Victim No.1] stepped on the missed PMN. The missed mine was located approximately 1.5 metres from the marked PMN.

Ddasaccident798, Hd-Aid

Global CWD Repository

During the sampling of the cleared area the TA continued prodding (each 2 centimetres) into the clear and unclear area as an overlap and excavating any resistance on the prodder in the very loose sand. Without any prodding force a detonation took place causing 1 PMN AP to explode.

Ddasaccident731, Hd-Aid

Global CWD Repository

While the deminer working in the Ren. Belt (B) clearing the AP M14 in cluster 8 last section home side dir 9 o’clock a pressure applied on the top of the AP mine which caused the mine blast and it’s considered as an individual mistake.

Ddasaccident746, Hd-Aid

Global CWD Repository

The deminer was working in SML D which contains M14 AP mines, he indicated the location of the mine then used the light rake then excavated using the heavy rake, during the excavation for the mine using the heavy rake the deminer accidentally caused a pressure on the AP mine pressure plate which caused the detonation.

Ddasaccident720, Hd-Aid

Global CWD Repository

The deminer was working in IOE containing M14 AP mines in Section 3 in Sabha 11, he used the MD to indicate the location of the mine then used the light rake then excavated using the heavy rake, during the excavation for the mine using the heavy rake, the deminer hit accidentally the AP mine on the top which detonated the mine.

Ddasaccident742, Hd-Aid

Global CWD Repository

According to external investigation report, the accident happened during the prodding operation on a detected signal. According to the witness statements the deminer may had been failed to pinpoint the signal or he may had started prodding directly from the top of it and not maintained the right angle of the prodder. The density of rocks there and hardness of the ground required more attention to be paid by deminer during the operation, but it seems that he was working in hurry without considering standard operating procedures to be applied during signal investigation. The record of QA shows that this …

Ddasaccident722, Hd-Aid

Global CWD Repository

According to external investigation report, the witness statements, injuries of involved de-miners and physical observation of the accident point, the accident occurred when [Victim No.1] was cutting bushes with scissor. During cutting off bushes in his clearance lane, he moved his right foot forward beyond the base stick, stepped on a Type-72 mine and caused it to go off. This accident caused traumatic amputation to his right foot below the ankle joint and left leg injuries. This also caused multiple injuries to the second deminer [Victim No.2], who was busy in marking the same lane in a 5 meters distance …

Ddasaccident590, Hd-Aid

Global CWD Repository

On the 8th of December 2010 a demining accident occurred at site NR-880 near the town of El Maria within the Kassala locality in which a deminer sustained traumatic injuries whilst conducting prodder drills and thus initiating a No4 AP mine. Immediate medical care was rendered to the injured deminer who was maintained in a stable condition.

Ddasaccident710, Hd-Aid

Global CWD Repository

According to investigation report and the observation of accident point, the accident occurred in un-cleared area within the minefield. The deminer was returning back from the rest area to resume the work in his clearance lane, he entered into the minefield, stepped on PMN2 anti-personnel mine and accident happened. The worksite was well prepared and the area was clearly marked in accordance to the [Demining group] SOPs. The deminer did not consider and use the clear access lane to proceed to his working area while he was well aware about the cleared/un-cleared parts of the minefield. He was not stopped …

Ddasaccident719, Hd-Aid

Global CWD Repository

On 22 December 2010 team arrived to the area on 06:30 and started operation on 07:00 working for 45 minutes and then 15 minutes break, the second round started on 08:00 for the same working and breaking period. The third round started on 09:00, [the Victim] worked in his clearance lane using metal detector and then stopped on 09:25 wanted to mark his clearance lane. He picked up marking material/equipment attempted to mark his clearance lane. On the way back he slipped out from his cleared lane to un-clear area, his right foot came on a mine and the accident …

Ddasaccident740, Hd-Aid

Global CWD Repository

On the 13th Dec 2010 at 10:37, the deminer [Victim No.1] was operating in his clearance lane excavating a detected signal, his prodder touched on a subsurface tripwire of POMZ mine which caused it to explode. According to the investigation report the signal was not pinpointed correctly and the de-miner has used pick in contrary to set procedure, during the excavation, he pulled the subsurface tripwire connected with POMZ mine. The accident resulted in superficial injuries to deminer’s hands, left thigh and left side of abdomen.

Ddasaccident801, Hd-Aid

Global CWD Repository

The deminer was busy with clearance in M/F No3, Lane No1 and had an indication from his F3 mine detector. He then carried out the prodder drill investigating the signal and the mine detonated. It is unclear at present why the No4 A/P mine detonated. It appears that the mine was slightly outside the 10cm overlap of the basestick but this could not be confirmed due to the movement of the marking rocks and base stick when the blast occurred.

Ddasaccident714, Hd-Aid

Global CWD Repository

I remember on the 25th of Oct. 2010 on the first part of work I cleared 3 AP mines from the first cluster as all the AT mines are cleared from the belt, then I headed to the next cluster following the team leader orders and started removing a 12 o’clock mine, when I was near its suggested location after making visual check and cleared the grass around it using the light rake I were no injuries thanks god, then the team leader came with deminer {name removed] and checked me and evacuated me walking to the ambulance which was …

Ddasaccident591, Hd-Aid

Global CWD Repository

On the 15th of October 2010 a demining accident occurred on site DA-SS-2091 in the Kapoeta locality of Eastern Equatoria where the international TFM sustained fatal injuries due to an uncontrolled detonation which occurred whilst his excavating/preparing a No4 AP mine for demolitions in situ. After initial medical care, the seriously injured TFM later succumbed to his wounds while on the Kapoeta airstrip under the attention of medical personnel awaiting air evacuation to more suitable medical facilities.

Ddasaccident808, Hd-Aid

Global CWD Repository

At 08:16 the Head of the Operational Management of [Demining group] Mr.[Name removed] reported to the radio-operator [Name removed] about mine explosion in the mine field No. 2 - Arjamazor village Kevron. A deminer of the group #4 [the Victim] was injured from PMN-2 and ML-7. Their characteristics are indicated in below table.

Ddasaccident753, Hd-Aid

Global CWD Repository

On the 7th Oct 2010 at 08:40, the deminer [the Victim] initiated a PMN anti-personnel mine with a pick outside of his clearance lane which caused the accident. The section leader was around 60 meters away busy in taking coordinates of a found mine with GPS and the team leader was busy in admin area updating the attendance sheet. The deminer was busy in the minefield without being observed by the command group for almost 15 minutes during the operation while the accident happened.

Ddasaccident703, Hd-Aid

Global CWD Repository

The deminer was working in the centre lane in the main minefield 346 and he recovered 6 M14 APs. At 12:15 hrs he started to approach AP M14 and he located one cluster then he moved to the next one, and while he was conducting visual check stage, he did not follow the proper procedure to remove the grass ,instead of using grass cutter to remove the grass he used his bared hand to pull the grass which accidentally caused the blast.

Ddasaccident640, Hd-Aid

Global CWD Repository

According to the witness statements and the physical observation of the accident point, the accident happened while the de-miner was walking from the rest area to his clearance lane. He stepped on missed PMN anti-personnel mine in cleared area. Therefore, this mine was missed during the clearance operation. The exploded mine resulted in below knee amputation of deminer’s right leg, multiple injuries on his left leg, left foot heel, right hand palm and some minor injuries on his right arm. The de-miner was sent to Khost hospital after receiving first aids in the site. While accident happened the de-miner did …

Ddasaccident655, Hd-Aid

Global CWD Repository

Deminer was approaching 9 O’clock M35 AP mine on one of the main mine belt clusters, after she removed the AT mine she located the M35 mine and started to excavate beside the mine, accidently she hit the mine by the heavy rake and caused the blast

Ddasaccident759, Hd-Aid

Global CWD Repository

On 06 Sep 2010, when Mr. [the Victim] was working in his clearance lane and excavated a detected signal, during the excavation drill his excavation tool touched the mine and caused it to go off. According to investigation report the cause of the accident was the wrong excavation technique, as he started excavation drill close to the pinpointing target. He had gone down and did not expand the trench to allow entry from the side, which caused to stroke his excavation tool on the top of the mine. Due to the injuries sustained on his eyes, it seems that the …

Ddasaccident693, Hd-Aid

Global CWD Repository

While the deminer was clearing an area assigned to him by the team leader and after he recovered an AT Saci mine he entered the contaminated hazardous area trying to locate the AP M14 12 o’clock mine with out following the SOP and the proper procedure , then he stepped on a non cleared area and activated the M14 which caused a badly injured to his left foot.

Ddasaccident729, Hd-Aid

Global CWD Repository

On 17 August 2010 while [the Victim] was working in his clearance lane, his excavation tool touched a mine and caused it to go off. According to the investigation report and the injuries sustained by victim deminer, it seems that the de-miner has excavated a detected signal carelessly and in contrary to their SOP. It means signal was not pinpointed correctly and the de-miner had used the excavation tool directly on the top of mine, so the accident happened. Unfortunately the de-miner did not put his PPE on, therefore, he got severe injuries on his eyes, whole face, neck, chest, …