Open Access. Powered by Scholars. Published by Universities.®

Social and Behavioral Sciences Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 8 of 8

Full-Text Articles in Social and Behavioral Sciences

Influence Of Geogrid On The Drying Shrinkage Performance Of Concrete Pavements, Abbas Sahib Abd-Ali Al-Hedad, Ebony Bambridge, Muhammad N. S Hadi Jan 2017

Influence Of Geogrid On The Drying Shrinkage Performance Of Concrete Pavements, Abbas Sahib Abd-Ali Al-Hedad, Ebony Bambridge, Muhammad N. S Hadi

Faculty of Engineering and Information Sciences - Papers: Part B

The aim of this study is to investigate the effect of geogrid on the drying shrinkage behaviour of concrete pavements. For this purpose, two categories of concrete specimens were prepared and tested by drying them within the controlled environmental conditions, for 56 days. The first category of specimens included casting and testing nine concrete prism specimens having dimensions of 75 x 75 x 280 mm. These specimens were divided into three groups. The first group included three unreinforced concrete prism specimens and taken as references. The second group consisted of three concrete prism specimens reinforced with a single biaxial geogrid …


Performing Under Pressure: Exploring The Psychological State Underlying Clutch Performance In Sport, Christian F. Swann, Lee Crust, Patricia C. Jackman, Stewart A. Vella, Mark S. Allen, Richard J. Keegan Jan 2017

Performing Under Pressure: Exploring The Psychological State Underlying Clutch Performance In Sport, Christian F. Swann, Lee Crust, Patricia C. Jackman, Stewart A. Vella, Mark S. Allen, Richard J. Keegan

Faculty of Social Sciences - Papers (Archive)

Clutch performance is improved performance under pressure. However little research has examined the psychological state experienced by athletes in these situations. Therefore, this study qualitatively examined the subjective experience underlying clutch performance across a range of sports (e.g., team, individual) and standards (Olympic to recreational athletes). Sixteen athletes (Mage = 27.08 years; SD = 6.48) took part in in-depth, semi-structured interviews primarily after an exceptional performance (M = 4.38 days later; SD = 3.14). Data were analysed inductively and thematically. Clutch states involved 12 characteristics, including heightened and deliberate concentration, intense effort, and heightened awareness, which distinguished the experience of …


Proeva: Runtime Proactive Performance Evaluation Based On Continuous-Time Mardov Chains, Guoxin Su, Taolue Chen, Yuan Feng, David Rosenblum Jan 2017

Proeva: Runtime Proactive Performance Evaluation Based On Continuous-Time Mardov Chains, Guoxin Su, Taolue Chen, Yuan Feng, David Rosenblum

Faculty of Engineering and Information Sciences - Papers: Part B

Software systems, especially service-based software systems, need to guarantee runtime performance. If their performance is degraded, some reconfiguration countermeasures should be taken. However, there is usually some latency before the countermeasures take effect.


Impact Of Structural Design Solutions On The Energy And Thermal Performance Of An Australian Office Building, Mehdi Robati, Georgios Kokogiannakis, Timothy J. Mccarthy Jan 2017

Impact Of Structural Design Solutions On The Energy And Thermal Performance Of An Australian Office Building, Mehdi Robati, Georgios Kokogiannakis, Timothy J. Mccarthy

Faculty of Engineering and Information Sciences - Papers: Part B

Concrete is a heavyweight construction material whose high thermal mass could increase the thermal storage capacity of a building envelope and in turn affect indoor thermal comfort. Selecting an appropriate method for concrete construction and form could also affect the total energy performance and thermal comfort of a building, a fact that is often overlooked by structural engineers. This study presents the results of energy simulations of the potential impact that concrete construction forms, in particular two slab types, and structural materials have on the energy consumption of archetypal commercial office buildings in five major Australia cities (Sydney, Melbourne, Canberra, …


Performance Evaluation Of A Novel Frost-Free Air-Source Heat Pump Integrated With Phase Change Materials (Pcms) And Dehumidification, Zhihua Wang, Fenghao Wang, Zhenjun Ma, Chun Li, Yibo Xu Jan 2017

Performance Evaluation Of A Novel Frost-Free Air-Source Heat Pump Integrated With Phase Change Materials (Pcms) And Dehumidification, Zhihua Wang, Fenghao Wang, Zhenjun Ma, Chun Li, Yibo Xu

Faculty of Engineering and Information Sciences - Papers: Part B

Air-source heat pump (ASHP) has been widely used in domestic and commercial buildings because of its energy savings, high efficiency and environmental friendliness. However, the heating capacity of an ASHP system is greatly influenced by the frost accumulation on the surface of the outdoor exchanger. To solve this problem, a novel frost-free ASHP system, integrating with Phase Change Materials (PCMs) and dehumidification, has been developed. In this paper, the schematic design of this system is first presented. The effect of the match relationship between the desiccant materials and PCM thermal energy storage on the performance of the novel system is …


Thermal Performance Evaluation Of An Integrated Photovoltaic Thermal-Phase Change Material System Using Taguchi Method, Haoshan Ren, Wenye Lin, Zhenjun Ma, Wenke Fan Jan 2017

Thermal Performance Evaluation Of An Integrated Photovoltaic Thermal-Phase Change Material System Using Taguchi Method, Haoshan Ren, Wenye Lin, Zhenjun Ma, Wenke Fan

Faculty of Engineering and Information Sciences - Papers: Part B

This paper presents the performance evaluation of an integrated photovoltaic thermal (PVT) collector-phased change material (PCM) thermal energy storage (TES) system. The PVT collectors can generate both electricity and low-grade thermal energy during the daytime, and the thermal energy generated can be temporarily stored in the PCM TES unit and used for space heating during the night-time. Taguchi method and analysis of variance are used for the simulation design and data analysis, respectively. The thermal performance of the proposed system was evaluated in terms of the useful energy stored in the TES system. The results showed that the outlet air …


Performance Simulation Of A Ground Source Heat Pump System Integrated With Solar Photovoltaic Thermal Collectors For Residential Application, Lei Xia, Zhenjun Ma, Georgios Kokogiannakis Jan 2017

Performance Simulation Of A Ground Source Heat Pump System Integrated With Solar Photovoltaic Thermal Collectors For Residential Application, Lei Xia, Zhenjun Ma, Georgios Kokogiannakis

Faculty of Engineering and Information Sciences - Papers: Part B

This paper presents the simulation and performance evaluation of a ground source heat pump (GSHP) system integrated with water-based solar photovoltaic thermal (PVT) collectors for residential buildings. A dynamic simulation system is developed using TRNSYS and used to facilitate the performance evaluation of the system. A 20-year life-time performance simulation is performed under three operation scenarios with different sizes of the PVT collectors. The results showed that the performance of the system is highly dependent on the size of the PVT collectors. Furthermore, an economic analysis is carried out to determine the optimum size of the PVT collectors for the …


The Effect Of Imputing Missing Clinical Attribute Values On Training Lung Cancer Survival Prediction Model Performance, Mohamed S. Barakat, Matthew Field, Aditya K. Ghose, David Stirling, Lois C. Holloway, Shalini K. Vinod, Andre Dekker, David Thwaites Jan 2017

The Effect Of Imputing Missing Clinical Attribute Values On Training Lung Cancer Survival Prediction Model Performance, Mohamed S. Barakat, Matthew Field, Aditya K. Ghose, David Stirling, Lois C. Holloway, Shalini K. Vinod, Andre Dekker, David Thwaites

Faculty of Engineering and Information Sciences - Papers: Part B

According to the estimations of the World Health Organization and the International Agency for Research in Cancer, lung cancer is the most common cause of death from cancer worldwide. The last few years have witnessed a rise in the attention given to the use of clinical decision support systems in medicine generally and in cancer in particular. These can predict patients' likelihood of survival based on analysis of and learning from previously treated patients. The datasets that are mined for developing clinical decision support functionality are often incomplete, which adversely impacts the quality of the models developed and the decision …