Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Agronomy and Crop Sciences
Stored Grain Pack Factor Measurements For Soybeans, Grain Sorghum, Oats, Barley, And Wheat, Rumela Bhadra, Mark E. Casada, Aaron P. Turner, Michael D. Montross, Sidney A. Thompson, Samuel G. Mcneill, Ronaldo G. Maghirang, Josephine M. Boac
Stored Grain Pack Factor Measurements For Soybeans, Grain Sorghum, Oats, Barley, And Wheat, Rumela Bhadra, Mark E. Casada, Aaron P. Turner, Michael D. Montross, Sidney A. Thompson, Samuel G. Mcneill, Ronaldo G. Maghirang, Josephine M. Boac
Biosystems and Agricultural Engineering Faculty Publications
Grain and oilseed crops stored in bins undergo compaction due to overbearing pressure of the grain inside the structure. Thus, volume measurements of grain in bins need to be combined with the amount of packing (usually called pack factor) in addition to the initial density so that the mass in the structure can be calculated. Multiple pack factor prediction methods are in use in the grain industry, but they have only been validated in the literature and compared with field data for corn and hard red winter wheat. Predictions from WPACKING, the program in ASABE Standard EP413.2, and two standard …
Field-Observed Angles Of Repose For Stored Grain In The United States, Rumela Bhadra, Mark E. Casada, Sidney A. Thompson, Josephine M. Boac, Ronaldo G. Maghirang, Michael D. Montross, Aaron P. Turner, Samuel G. Mcneill
Field-Observed Angles Of Repose For Stored Grain In The United States, Rumela Bhadra, Mark E. Casada, Sidney A. Thompson, Josephine M. Boac, Ronaldo G. Maghirang, Michael D. Montross, Aaron P. Turner, Samuel G. Mcneill
Biosystems and Agricultural Engineering Faculty Publications
Bulk grain angle of repose (AoR) is a key parameter for inventorying grain, predicting flow characteristics, and designing bins and grain handling systems. The AoR is defined for two cases, piling (dynamic) or emptying (static), and usually varies with grain type. The objective of this study was to measure piling angles of repose for corn, sorghum, barley, soybeans, oats, and hard red winter (HRW) wheat in steel and concrete bins in the United States. Angles were measured in 182 bins and 7 outdoor piles. The piling AoR for corn ranged from 15.7° to 30.2° (median of 20.4° and standard deviation …
Correlating Bulk Density (With Dockage) And Test Weight (Without Dockage) For Wheat Samples, Rumela Bhadra, Mark E. Casada, Josephine M. Boac, Aaron P. Turner, Sidney A. Thompson, Michael D. Montross, Ronaldo G. Maghirang, Samuel G. Mcneill
Correlating Bulk Density (With Dockage) And Test Weight (Without Dockage) For Wheat Samples, Rumela Bhadra, Mark E. Casada, Josephine M. Boac, Aaron P. Turner, Sidney A. Thompson, Michael D. Montross, Ronaldo G. Maghirang, Samuel G. Mcneill
Biosystems and Agricultural Engineering Faculty Publications
In grain bins, the compaction of stored grain is caused by the overbearing pressure of the bulk material in the bin. To predict the amount of grain in the bin, compaction values must be determined based on the average bulk density (BD) of the stored material. However, BD is determined following the Federal Grain Inspection Service (FGIS) guidelines for measuring test weight (TW), which require that dockage be removed prior to measuring wheat TW. Thus, this creates a problem for predicting grain compaction and conducting inventory studies, because the average BD of the grain in a bin for these calculations …
Stored Grain Pack Factors For Wheat: Comparison Of Three Methods To Field Measurements, Josephine M. Boac, Rumela Bhadra, Mark E. Casada, Sidney A. Thompson, Aaron P. Turner, Michael D. Montross, Samuel G. Mcneill, Ronaldo G. Maghirang
Stored Grain Pack Factors For Wheat: Comparison Of Three Methods To Field Measurements, Josephine M. Boac, Rumela Bhadra, Mark E. Casada, Sidney A. Thompson, Aaron P. Turner, Michael D. Montross, Samuel G. Mcneill, Ronaldo G. Maghirang
Biosystems and Agricultural Engineering Faculty Publications
Storing grain in bulk storage units results in grain packing from overbearing pressure, which increases grain bulk density and storage unit capacity. This study compared pack factors of hard red winter (HRW) wheat in vertical storage bins using different methods: the existing packing model (WPACKING), the USDA Risk Management Agency (RMA) method, and the USDA Farm Service Agency Warehouse Licensing and Examination Division (FSA-W) method. Grain bins containing HRW wheat were measured in Kansas, Oklahoma, and Texas. Packing was measured in corrugated steel bins and reinforced concrete bins with diameters ranging from 4.6 to 31.9 m (15.0 to 104.6 ft) …
Aeration Strategies And Fan Cost Comparisons For Wheat In Mid-South Production Regions, Thomas C. Bridges, Michael D. Montross, Samuel G. Mcneill
Aeration Strategies And Fan Cost Comparisons For Wheat In Mid-South Production Regions, Thomas C. Bridges, Michael D. Montross, Samuel G. Mcneill
Biosystems and Agricultural Engineering Faculty Publications
Numerous factors influence the sizing of aeration fans for summer-harvested crops. Thirty years of weather data for Lexington, Kentucky, were analyzed and the cost of aeration was compared for two axial fans (afan1, afan2) and one centrifugal fan (cfan1). Aeration costs were defined as the sum of the following components: the cost of owning the fan, the cost of electricity for operating the fan, a cost for wheat shrinkage during aeration, and a cost for dry matter loss (DML). The fans were selected to deliver airflow rates of approximately one, two, and three times the recommended aeration rate of 0.11 …