Other Engineering Commons^™

Investigation Of The Ternary System Silver-Aluminum-Indium (Ag-Al-In), Elvin H. Beardslee

Bachelors Theses and Reports, 1928 - 1970

This thesis paper contains material pertaining to & preliminary investigation of the ternary system Ag-Al-In. Procedures in this preliminary investigation are discussed in detail.

Physico-Chemical Principles Of Sixteenth Century Metallurgy, Robert E. Johnson

Bachelors Theses and Reports, 1928 - 1970

Following a review of sixteenth century metallurgical literature and a discussion of Gibbs free energy, this thesis discusses thermodynamic considerations of galena (PbS) reduction by iron from a lead assay of this period. The importance of fluxes in this assay is emphasized. The discussion covers both equilibrium and non-equilibrium conditions at 1100 degrees Celsius. Possible substitutes for iron are also covered.

Information from twenty-one small controlled lead assays is correlated with the thermodynamic discussion to determine the purpose of each constituent in the assay.

The Effect Of Ph Upon Chelation Reactions In Montmorillonite Clays, Joseph Michael Keane

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate several chelation reactions and determine the effect of variable pH upon these reactions.

Investigation Of Inclusions In Armco Ingot Iron, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Various chemical and electrolytic separation methods were investigated in an attempt to separate the in­clusions in Armco ingot iron. Residues obtained were X-rayed for identification purposes. The microstruc­tures of this iron were studied with the object of de­termining the relative sizes, locations, and possible compositions of the inclusions.

Polarographic Determination Of Germanium, Calvin Leo Stevenson

Bachelors Theses and Reports, 1928 - 1970

In the past germanium has been determined by either wet methods or by the spectograph; the spectograph being used for the determination of very small amounts of ger­manium and wet methods used when more than one hundredth of one percent germanium is present. Both of these analyti­cal schemes have weaknesses.

A Study Of The Effects Of The Chloride Ion On The Lead-Silver Anodes And On The Lead Tenor Of The Zinc Deposit In Zinc Electrolysis, William A. Mitchell

Bachelors Theses and Reports, 1928 - 1970

The electrolyte used in the commercial production of electrolytic zinc from zinc sulphate solutions contains small amounts of impurities each of which has its own effects upon the process. Impurities such as antimony, cobalt, nickel, and iron tend to lower the current efficiency while other impurities such as chlorine, fluorine, and nitrates tend to increase the corrosion of the lead anodes and thereby increase the lead tenor of the zinc deposit.

The Decomposition Of Calcium Tungstate And Synthetic Scheelite With Hydrochloric Acid, Robert R. Beebe

Bachelors Theses and Reports, 1928 - 1970

The decomposition of scheelite with hydrochloric acid was studied under conditions of variable acid concentration, time and temperature. The reactions were traced by weigh­ing material untransformed and, in some cases, by analyzing the transformation products.

A Study Of The Beneficiation Of Low-Grade Domestic Chromite, Darrell Edward Bodie

Bachelors Theses and Reports, 1928 - 1970

Chromite, a strategic mineral, is being consumed in ever increasing quantities in the United States today. Although the United States imports practically all of the chromite that is being consumed, it is gradually becoming necessary to exploit the low-grade deposits that are located within the United States, and also the low-grade deposits of Canada.

The Mechanical Production Of Zinc Dust, Charles A. Schroer

Bachelors Theses and Reports, 1928 - 1970

The object of this thesis is to produce zinc dust suitable for zinc leach purification, by direct application of a mechanical force on a stream of molten zinc.The project is a continuation of work done by Mr. D. S. Gleason, while working for his Master of Science degree in the spring of 1952.

Variation Of Induction And Hysteresis Curves For The Heusler Alloy, Cu2mna1, Ford W. Knight

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation is to determine the fundamental magnetic characteristics of induction and hysteresis, for the alloy Cu₂MnAl. This is a ternary, ferromagnetic Heusler alloy. The problem is not only to determine these characteristics for the alloy as-cast but to heat treat it and observe the manner in which different heat treat­ments affect these two fundamental magnetic characteristics.

The Mechanical Production Of Zinc Dust, Robert F. Payne

Bachelors Theses and Reports, 1928 - 1970

It was the purpose of this investigation to delve further into the possibility of producing, by mechanical means, a zinc dust which might be suitable for the puri­fication of zinc leach solution.

The Immersion Coating Of Indium Upon Magnesium From Sulphate Solutions Containing Flourides, John J. Harrington

Bachelors Theses and Reports, 1928 - 1970

The thesis problem that will be discussed in this report is an investiga­tion of a method of plating a coating of indium upon magnesium and magnesium alloys. The method used to accomplish the final results is the immersion pro­cess. It can be defined as the process of coating a metal with a second metal by immersing the first in a solution containing ions of the second.

The Occurrence Of Molybdenite In The United States, Alaska, Canada, And Newfoundland, Richard W. Brummett

Bachelors Theses and Reports, 1928 - 1970

In this study of molybdenite and its occurrence, the pub­lished literature on 66 separate deposits was reviewed, sum­marized, and coordinated. The following descriptions are in­tended to point out the important features of molybdenite oc­currences as described in the literature.

The Metallography Of Aluminum Casting Alloys, Donald D. Goehler

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to supply the Montana School of Mines with an up to date source of information concerning the metallography of aluminum casting alloys. This thesis is designed as a continuing project. Ultimately, it is hoped that a catalog containing all the typical structures of aluminum casting alloys will develop.

An Investigation Of The Hardening Properties Of Some Alpha Copper Indium Alloys, Charles W. Mcpherson

Bachelors Theses and Reports, 1928 - 1970

Precipitation hardening alloys has assumed a major role in modern da^y development of alloys. In his search for stronger, harder materials, the metallurgist has often been limited by the cost of metals which posses the needed properties.

The Electrolytic Purification Of An Impure Cadmium Sulfate Solution With A Cell Utilizing A Mercury Cathode And A Lead Anode, W. D. Mcmaster

Bachelors Theses and Reports, 1928 - 1970

Cadmium is produced solely as a by-product and all cadmium of commerce is obtained from zinc ores. It is a rare occurrence when zinc deposits are found which do not contain some cadmium.

Determination Of The Activities Of Indium And Mercury And The Vapor Pressures Of Mercury Over These Amalgams From 0.00216 To 0.02494 Mole Fraction Indium At 25 C And From 0.00067 To 0.02410 Mole Fraction Indium At 70 C By Electromotive Force Measurements, Arthur H. Lutts

Bachelors Theses and Reports, 1928 - 1970

This work was performed to determine by experimental means the activities of both indium and mercury and the vapor pressures of mercury over these amalgams at 25 and 70 C.

Electrowinning Versus Electrorefining Of Blister Copper, Frank J. Vorell

Bachelors Theses and Reports, 1928 - 1970

In the following sections of this report, I will discuss as fully as possible both the theo­retical and practical aspects of the roasting, leaching, and electrowinning steps, as well as the economic considerations of the process. The results of my laboratory work will, of course, be integrated to the process.

Electrowinning With Amalgam Electrode, Ralph V. Anderson Jr.

Bachelors Theses and Reports, 1928 - 1970

Amalgam Metallurgy, a relatively new expression in the technology of metal extraction, was first chosen to describe certain new processes developed at the Duisburg Copper Works in Germany. The idea of using mercury, a costly and poisonous metal, as an intermediate in heavy chemical industry and in polarography are of recent origin; with the exception of a series of patents of little signif­icance and occasional comments in the literature, the work is hardly known.

The Influence Of Copper Upon The Age Hardening Properties Of Steel, Andre Rey

Bachelors Theses and Reports, 1928 - 1970

The virtues of alloy steels have been widely publi­cized in both technical literature and everyday adver­tising. Nearly everyone possessing a slight knowledge of metallurgy knows the beneficial effects of chromium in the manufacture of stainless steels, or the importance of nickel, molybdenum, vanadium, and other common elements used to alloy steels.

Resistance Of Solid Inconel To Attack By Liquid Indium, David C. Hendra

Bachelors Theses and Reports, 1928 - 1970

The role of liquid metals in industry is rap­idly becoming of increasing importance. The phys­ical and chemical tendencies of metals in the liq­uid condition must be ascertained before a metal in this form can be put to practical usage. In very many stages of mineral processing and recovery, in molten-metal baths for temperature control on heat treating, and in several industries where heat transfer is an important aspect, metals may be at one time or another in a liquid condition.

Isothermal Transformation Of S.A.E. 6150 Steel By The Magnetic Permability Method, Richard R. Douglas

Bachelors Theses and Reports, 1928 - 1970

Since the purpose of this thesis is primarily to present an improved mechanical method for plotting isothermal transformations by means of differential mag­netic permeability between untransformed austenite and its ultimate transformation product.

An Investigation Of The Precipitation Of Cobalt With Zinc Dust, Lyle Hallberg

Bachelors Theses and Reports, 1928 - 1970

Cobalt, as well as copper, cadmium, and other impurities, is removed by selective precipitation with zinc during the zinc electrolyte purification cycle, and the purification residue may be treated by a Cadmium Plant for the recovery of cadmium.

An Investigation Of Silicon Impregnation Of Low-Carbon Steels, Thomas E. Groce

Bachelors Theses and Reports, 1928 - 1970

A problem of metallurgy during the last part of the Nineteenth and the early Twentieth Century, and one that stood very near the front, was investigations of methods to produce a non-corrosive surface on iron and steel without affecting the physical properties of these base metals.

A Study Of The Transformation Of A Twenty-Eight Per Cent Tin Bronze, Perry A. Boukind

Bachelors Theses and Reports, 1928 - 1970

In this investigation, attention is directed to the phases covered by a 28 per cent tin alloy. When the investigation was started, consideration was given to the possibility of making a Time - Temperature - Transformation curve for this parti­cular alloy. As the work progressed and further research was carried on, this phase of the work was abandoned.

The Characteristics Of The Electrolyte In The Series System Of Electrolytic Copper Refining, Carl W. Howald Jr.

Bachelors Theses and Reports, 1928 - 1970

Almost everyone is familiar with the tremendous importance of copper in our everyday life. One of the pro­perties of copper which determines its great usefulness to mankind is its electrical conductivity. This property alone has more to do with the prominence of copper among useful metals then does any other.

A Study Of The Diffusion Of Electroplated Coatings In The Solid State., Michael R. Writt

Bachelors Theses and Reports, 1928 - 1970

The term diffusion means an equalization or homogenization of diverse materials. Specifically ap­plied to metals, diffusion is the interchange of atoms. It is, in effect, an invasion of one crystal lattice by the atoms of one or more other crystal lattices. Therefore, the study of diffusion must involve the geometry and physics of crystal lattices as well as their energies.

The Electrodeposition Of Copper-Cobalt Alloys, Richard L. Dunn

Bachelors Theses and Reports, 1928 - 1970

An attempt was made to deposit a 50:50 copper-cobalt alloy from various sulfate electrolytes. No true 50:50 alloy was obtained but various mixtures of cobalt and copper rich crystals were deposited.

Age Hardening Of Copper Antimony Alloys, William R. Stern

Bachelors Theses and Reports, 1928 - 1970

A large number of alloys of varying percentages of copper and antimony were prepared. These alloys were treated in various ways which might be expected to produce age hardening. The effect of cold working was studied in the range where the alloys were malleable.

The Determination Of Aluminum In The Presence Of Manganese And Iron By The Use Of A Mercury Cathode, William R. Opie

Bachelors Theses and Reports, 1928 - 1970

Since 1880, when Wolcott Gibbs made the suggestion that mercury could be used as a cathode in gravimetric electroanalysis, many articles have appeared in literature either criticizing the method or citing successful results which have been obtained by it.