Operations Research, Systems Engineering and Industrial Engineering Commons^™

S&G Metal Fab Battery Tray, Matthew Nartatez

Industrial and Manufacturing Engineering

This report was written for the design of a battery tray and manufacturing process for S&G Metal Fab. The manufacturing steps of how to process the sheet metal to create the product are defined and documented in this report. This project began with constraints given by S&G and were all accomplished using coursework knowledge obtained as a manufacturing engineer student at Cal Poly San Luis Obispo. This report mainly covers parameters regarding the cutting, bending and, deforming of sheet metal to acquire the desired shapes and sizes. It also analyzes the costs that are associated with these processes and material. …

The Design, Testing, And Manufacturing Of A Pin Fin Extrusion Heat Sink, Arash Michael Mira

Industrial and Manufacturing Engineering

My senior project focuses on the design, testing, and manufacturing of pin fin extrusion heat sinks that are you used to cool simple electronic applications across a multitude of markets. Without the modern day heat sink, electronics that we have become familiar with throughout our everyday lives will cease to exist. I will design these heat sinks using Solid Works 3D CAD. I will then test the heat sinks using ICEPAK CFD software, where I will model the heat sink against a 5 watt application, inside of a cabinet that models the chassis of a computer. After receiving these results, …

Manufacturing Strategy & Operations: Reflections On Key Current Issues: Challenges And Associated Human Resource Implications, Lorraine Mcgrath

Books/Book chapters

This chapter evaluates the current issues and challenges in defining a company’s manufacturing strategy and its production operations in consideration of the contemporary shift to low cost manufacturing locations. Competitive priorities of cost, quality, delivery and flexibility are reviewed. The structural and infrastructure elements of a manufacturing strategy are outlined. Mitigating risks in a global arena are reviewed. Collaborative efforts, including the cultural and personality issues of being human are included in the discussion of managing diversity in such a highly competitive and challenging enterprise resource planning environment.

High Speed Turning Of Compacted Graphite Iron (Cgi) Using Controlled Modulation, Tyler Paul Stalbaum

Open Access Theses

Compacted graphite iron (CGI) is a material which emerged as a candidate material to replace cast iron (CI) in the automotive industry for engine block castings. Its thermal and mechanical properties allow the CGI-based engines to operate at higher cylinder pressures and temperatures than CI-based engines, allowing for lower fuel emissions and increased fuel economy. However, these same properties together with the thermomechanical wear mode in the CGI-CBN system result in poor machinability and inhibit CGI from seeing wide spread use in the automotive industry.

In industry, machining of CGI is done only at low speeds, less than V = …