Operations Research, Systems Engineering and Industrial Engineering Commons^™

Development Of Integrated Process Simulation System Model For Spent Fuel Treatment Facility (Sftf) Design: Quarterly Report October 1-December 31, 2004, Yitung Chen, Sean Hsieh

Separations Campaign (TRP)

The Advanced Fuel Cycle Initiative (AFCI) and Transmutation Research Program- University Participation Program (TRP-UPP) supported by Department of Energy of the United States have been developing many important technologies for the transmutation of nuclear waste to address long-term disposal issues. While successfully embedding AMUSE module into a dedicated System Engineering Model (TRPSEMPro), developed by the Nevada Center for Advanced Computational Methods (NCACM) at the University of Nevada, Las Vegas collaborating with Argonne National Laboratory (ANL), ANL is interested in further simulating the Light Water Reactor (LWR) Spent Fuel Treatment Facility (SFTF) combining commercial process simulation and analysis packages and core …

Academic Audit Of Afit Programs In Systems Engineering, United States Air Force Scientific Advisory Board

AFIT Documents

This report provides an assessment and recommendations for the systems engineering educational programs at the Air Force Institute of Technology (AFIT). The Air Force needs in systems engineering education are briefly summarized, followed by an analysis of the educational program at AFIT. Based on the assessment of AFIT's program, a set of recommendations are given for improving the programs and their utility to the Air Force. Appendices to the report contain additional information on the AFIT programs and an assessment of other graduate systems engineering programs in the US.

Evaluation Of Bus And Truck Automation Operations Concepts, H.-S. Jacob Tsao, Lan Zhang, Lin Lin, Deepa Batni

Faculty Publications

Traffic congestion will continue to worsen and likely worsen at a faster rate than ever. People throughput and freight throughput have become critical issues for California and the rest of the nation. PATH has funded with approximately $125K a research project entitled “Evaluation of Bus and Truck Automation Scenarios” jointly proposed by Jan Botha (Principal Investigator) of Department of Civil and Environmental Engineering and Jacob Tsao (Co-PI) of Department of Industrial and Systems Engineering at San Jose State University. This report summarizes the major findings of the research conducted by Professor Tsao and his assistants with approximately $44K out of …

Development Of A Systems Engineering Model Of The Chemical Separations Process, Yitung Chen, Sean Hsieh

Separations Campaign (TRP)

The whole chemical separation process is complex to the point that definitely requires certain level of systematic coordination. To perform smoothly and meet the target extraction rates among those processes, this research proposed a general-purpose systems engineering model.

A general purposed systems engineering model, Transmutation Research Program System Engineering Model Project (TRPSEMPro), was developed based on the above design concept. The system model includes four main parts: System Manager, Model Integration, Study Plan, and Solution Viewer. System Manager supervises all the case (problem) creation, and functionality definition. Model Integration identifies chemical extraction processes and their execution sequence. Study Plan is …

Development Of A Systems Engineering Model Of The Chemical Separations Process: Final Report, Yitung Chen, Sean Hsieh

Separations Campaign (TRP)

The whole chemical separation process is complex to the point that definitely requires certain level of systematic coordination. To perform smoothly and meet the target extraction rates among those processes, this research proposed a general-purpose systems engineering model.

A general purposed systems engineering model, Transmutation Research Program System Engineering Model Project (TRPSEMPro), was developed based on the above design concept. The system model includes four main parts: System Manager, Model Integration, Study Plan, and Solution Viewer. TRPSEMPro can apply not only to chemical separation process, but also a general system model.

Software engineering and Object Oriented Analysis and Design (OOA&D) …

Feedback Linearization Based Power System Stabilizer Design With Control Limits, Wenxin Liu, Ganesh K. Venayagamoorthy, Donald C. Wunsch, Jagannathan Sarangapani

Electrical and Computer Engineering Faculty Research & Creative Works

In power system controls, simplified analytical models are used to represent the dynamics of power system and controller designs are not rigorous with no stability analysis. One reason is because the power systems are complex nonlinear systems which pose difficulty for analysis. This paper presents a feedback linearization based power system stabilizer design for a single machine infinite bus power system. Since practical operating conditions require the magnitude of control signal to be within certain limits, the stability of the control system under control limits is also analyzed. Simulation results under different kinds of operating conditions show that the controller …

Prediction Of Growth Factor Effects On Engineered Cartilage Composition Using Deterministic And Stochastic Modeling, Sean S. Kohles, Asit K. Saha, J. (Jagannath) Mazumdar

Mechanical and Materials Engineering Faculty Publications and Presentations

In the design of engineered tissues, guided balance of biomaterial degeneration with tissue synthesis offers refined control of construct development. The objective of this study was to develop a mathematical model that describes the steady state metabolism of extracellular matrix molecules (ECM: glycosaminoglycan and collagen) in an engineered cartilage construct taking into account localized environmental changes that may arise because of the application of growth factors. The variable effects of growth factors were incorporated in the form of random noise rather than the difference in rates of synthesis and catabolism. Thus, the frequency of ECM accumulation for each matrix molecule …

Development Of Integrated Process Simulation System Model For Spent Fuel Treatment Facility (Sftf) Design, Yitung Chen, Sean Hsieh

Separations Campaign (TRP)

The Advanced Fuel Cycle Initiative (AFCI) and Transmutation Research Program-University Participation Program (TRP-UPP) supported by Department of Energy of the United States have been developing many important technologies for the transmutation of nuclear waste to address long-term disposal issues. While successfully embedding AMUSE module into a dedicated System Engineering Model (TRPSEMPro), developed by the Nevada Center for Advanced Computational Methods (NCACM) at the University of Nevada-Las Vegas collaborating with Argonne National Laboratory (ANL), ANL is interested in further simulating the Light Water Reactor (LWR) Spent Fuel Treatment Facility (SFTF) combining commercial process simulation and analysis packages and core calculation of …

Information Model For Engineering Change Management, Clifford L. Panokarren

FIU Electronic Theses and Dissertations

Managing engineering changes is a critical task for organizations to remain competitive. In a manufacturing organization there are innumerable engineering change requests. This thesis is focused on the development of an information model that defines the engineering change process.

This research developed an activity model in IDEF0, an object model in IDEF1X and a dynamic model using state diagrams. The activity model captures the business process for executing an engineering change in terms of its constituting activities and sub-activities. The object model defines each object and its attributes identified in the activity model. The dynamic model captures the status change …

Development Of A Systems Engineering Model Of The Chemical Separations Process, Yitung Chen, Darrell Pepper, Sean Hsieh

Separations Campaign (TRP)

The chemical processing of used nuclear fuel is an integral component of any strategy for the transmutation of nuclear waste. Due to the large volume of material that must be handled in this first step of the transmutation process, the efficiency of the separations process is a key factor in the potential economic viability of the transmutation strategies. The ability to optimize the chemical separation systems is vital to ensure the feasibility of the transmutation program.

Systems analysis, or total systems modeling, is one of the strongest tools available to researchers for understanding and optimizing complex systems such as chemical …

Lean Product Development Flow, Bohdan W. Oppenheim

Systems Engineering Faculty Works

A general holistic framework, also called a process—named “Lean Product Development Flow (LPDF)”—for organizing the engineering work of Product Development (PD), has been proposed as a contribution to the emerging field of Lean Systems Engineering. The framework is based on Lean Principles, with emphasis on PD value-pulling workflow pulsed by takt periods. The value is defined as (1) mission assurance/product quality, (the traditional goals of Systems Engineering) and (2) reduced program cost and schedule achieved by a radical reduction of waste. LPDF is recommended for smaller design programs based on a high degree of legacy knowledge, with technologies mature enough …

Decentralized Neural Network Control Of A Class Of Large-Scale Systems With Unknown Interconnection, Wenxin Liu, Jagannathan Sarangapani, Donald C. Wunsch, Mariesa Crow

Electrical and Computer Engineering Faculty Research & Creative Works

A novel decentralized neural network (DNN) controller is proposed for a class of large-scale nonlinear systems with unknown interconnections. The objective is to design a DNN for a class of large-scale systems which do not satisfy the matching condition requirement. The NNs are used to approximate the unknown subsystem dynamics and the interconnections. The DNN is designed using the back stepping methodology with only local signals for feedback. All of the signals in the closed loop (system states and weights estimation errors) are guaranteed to be uniformly ultimately bounded and eventually converge to a compact set.