Operations Research, Systems Engineering and Industrial Engineering Commons^™

A Study Of The Effect Of Machine Parameters On Defects Produced In Eos Additive Manufacturing Builds, Tina White Malone

Doctoral Dissertations

⁵Additive Manufacturing (AM) is defined in the American Society for Testing and Materials (ASTM) standard F2792 as “a process of joining materials to make objects from 3D model data, usually layer upon layer, as opposed to subtractive manufacturing methodologies. It provides an advanced method for building complex geometries and parts for high performance with a significant cost savings. ⁵⁵It’s advantages include the reduced need for tools and molds commonly used in manufacturing, a large reduction in wasted material, much shorter manufacturing cycles for the building of hardware, and its uniquely inherent ability to produce much more complex shapes. …

Quality And Productivity Improvements In Additive Manufacturing, Huseyin Kose

Doctoral Dissertations

Additive manufacturing (AM) is a relatively new manufacturing technology compared to the traditional manufacturing methods. Even though AM processes have many advantages, they also have a series of challenges that need to be addressed to adapt this technology for a wide range of applications and mass production.

AM faces a number of challenges, including the absence of methods/models for determining whether AM is the best manufacturing process for a given part. The first study of this thesis proposes a framework for choosing specific AM processes by considering the complexity level of a part. It has been proven that the method …

Sustainability Analysis For New Technologies Of Biofuels And Additive Manufacturing, Nelson A. Granda Marulanda

Doctoral Dissertations

This work is a compendium of different sustainability analysis on new technologies. The first chapter performed a Life Cycle Analysis of a biofuel process where pine woodchips are used to create SynGas. The study was done using a 10 tons gasifier, the mass balance of the reaction and an input/output analysis. All the data obtained was input into a freeware LCA software and the results were compared to the use of regular produced natural gas. The second chapter creates a benchmark of energy intensity and presents a case using binder jetting technology. Different Additive Manufacturing technologies energy intensity was reported, …