Nanoscience and Nanotechnology Commons^™

Towards Sustainable Development Of Nanomanufacturing, Sasikumar Ramdas Naidu

Doctoral Dissertations

"Sustainability" is a buzz word these days not just among regulatory agencies but even with corporations, as evident by the release of annual sustainability report by a large number of firms. Companies are starting to portray profit making along with corporate environmental responsibility.

Nanotechnology and nanomanufacturing which holds a lot of promise for development in a multitude of fields in science and engineering is the new kid on the block and carries a lot of apprehension due to public concern about their potential unwanted side effects that may result in the case of an untoward incident or lack of oversight. …

Synthesis And Characterization Of Nanocomposites For Electrochemical Capacitors, Farah Alvi

USF Tampa Graduate Theses and Dissertations

Presently there are deep concerns over the environmental consequences and the consumption of non-renewable energy sources, with the accelerated greenhouse effect, triggered enormous interest in the use of renewable energy sources e.g., solar, hydropower, wind and geothermal. However the intermittent nature of harvesting renewable energy sources has recently gained considerable attention in the alternative reliable, cost effective, and environmentally friendly energy storage devices. The supercapacitor and lithium ion batteries are considered more efficient electrical energy storage devices than conventional energy storage systems.

Both devices have many useful and important applications; they could be an excellent source for high power and …

Microscopic And Spectroscopic Analysis Of Wo3 And Ti-Doped Wo3 Thin Films, Young Taek Yun

Open Access Theses & Dissertations

Tungsten oxide (WO3) has been a subject of high interest for its unique properties, and recently for its importance in different types of industrial applications which ranges from non-emissive displays, optical, microelectronic, catalytic/photocatalytic, humidity, temperature, gas, and biosensor devices. In this study, WO3 and Ti doped thin films were prepared using radio frequency magnetron reactive sputtering at different substrate temperatures ranging from room temperature to 500 ºC in increments of 100 ºC. After forming a hypothesis based on knowledge of established WO3 properties, we attempt in this work to investigate how the doping influences the roughness and the mean grain …