Nanoscience and Nanotechnology Commons^™

Thermal Conductivity And Mechanical Properties Of Interlayer-Bonded Graphene Bilayers, Afnan Mostafa

Masters Theses

Graphene, an allotrope of carbon, has demonstrated exceptional mechanical, thermal, electronic, and optical properties. Complementary to such innate properties, structural modification through chemical functionalization or defect engineering can significantly enhance the properties and functionality of graphene and its derivatives. Hence, understanding structure-property relationships in graphene-based metamaterials has garnered much attention in recent years. In this thesis, we present molecular dynamics studies aimed at elucidating structure-property relationships that govern the thermomechanical response of interlayer-bonded graphene bilayers.

First, we present a systematic and thorough analysis of thermal transport in interlayer-bonded twisted bilayer graphene (IB-TBG). We find that the introduction of interlayer C-C …

Phonon Transport At Boundaries And Interfaces In Two-Dimensional Materials, Cameron Foss

Masters Theses

A typical electronic or photonic device may consist of several materials each one potentially meeting at an interface or terminating with a free-surface boundary. As modern device dimensions reach deeper into the nanoscale regime, interfaces and boundaries become increasingly influential to both electrical and thermal energy transport. While a large majority of the device community focuses on the former, we focus here on the latter issue of thermal transport which is of great importance in implementing nanoscale devices as well as developing solutions for on-chip heat removal and waste heat scavenging. In this document we will discuss how modern performance …

High Strain Rate Dynamic Response Of Aluminum 6061 Micro Particles At Elevated Temperatures And Varying Oxide Thicknesses Of Substrate Surface, Carmine Taglienti

Masters Theses

Cold spray is a unique additive manufacturing process, where a large number of ductile metal micro particles are deposited to create new surface coatings or free-standing structures. Metallic particles are accelerated through a gas stream, reaching velocities of over 1 km/s. Accelerated particles experience a high-strain-rate microscopic ballistic collisions against a target substrate. Large amounts of kinetic energy results in extreme plastic deformation of the particles and substrate. Though the cold spray process has been in use for decades, the extreme material science behind the deformation of particles has not been well understood due to experimental difficulties arising from the …

Skynet: Memristor-Based 3d Ic For Artificial Neural Networks, Sachin Bhat

Masters Theses

Hardware implementations of artificial neural networks (ANNs) have become feasible due to the advent of persistent 2-terminal devices such as memristor, phase change memory, MTJs, etc. Hybrid memristor crossbar/CMOS systems have been studied extensively and demonstrated experimentally. In these circuits, memristors located at each cross point in a crossbar are, however, stacked on top of CMOS circuits using back end of line processing (BOEL), limiting scaling. Each neuron’s functionality is spread across layers of CMOS and memristor crossbar and thus cannot support the required connectivity to implement large-scale multi-layered ANNs.

This work proposes a new fine-grained 3D integrated circuit technology …

High Performance Silver Diffusive Memristors For Future Computing, Rivu Midya

Masters Theses

Sneak path current is a significant remaining obstacle to the utilization of large crossbar arrays for non-volatile memories and other applications of memristors. A two-terminal selector device with an extremely large current-voltage nonlinearity and low leakage current could solve this problem. We present here a Ag/oxide-based threshold switching (TS) device with attractive features such as high current-voltage nonlinearity (~10¹⁰), steep turn-on slope (less than 1 mV/dec), low OFF-state leakage current (~10^-14 A), fast turn ON/OFF speeds (<75/250 ns), and good endurance (>10⁸ cycles). The feasibility of using this selector with a typical memristor has been demonstrated by physically integrating them …

Investigate The Interactions Between Silver Nanoparticles And Spinach Leaf By Surface Enhanced Raman Spectroscopic Mapping, Zhiyun Zhang

Masters Theses

Owing to their increasing application and potential toxicity, engineered nanoparticles (ENPs) have been considered as a potential agricultural contaminant that may pose unknown risk to human beings. However, many techniques require invasive and complicated sample preparation procedures to detect and characterize engineered nanomaterials in complex matrices. In the first part of this thesis, we present a non-destructive and label-free approach based on surface enhanced Raman spectroscopic (SERS) mapping technique to qualitatively detect and characterize gold nanoparticles (AuNPs), on and in spinach leaves in situ. We were able to detect the clearly enhanced signals from AuNPs at 15 to 125 nm …

Development Of Infrared And Terahertz Bolometers Based On Palladium And Carbon Nanotubes Using Roll To Roll Process, Amulya Gullapalli

Masters Theses

Terahertz region in the electromagnetic spectrum is the region between Infrared and Microwave. As the Terahertz region has both wave and particle nature, it is difficult to make a room temperature, fast, and sensitive detector in this region. In this work, we fabricated a Palladium based IR detector and a CNT based THz bolometer.

In Chapter 1, I give a brief introduction of the Terahertz region, the detectors already available in the market and different techniques I can use to test my detector. In Chapter 2, I explain about the Palladium IR bolometer, the fabrication technique I have used, and …