Open Access. Powered by Scholars. Published by Universities.®
Nanoscience and Nanotechnology Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Publication
- Publication Type
Articles 1 - 3 of 3
Full-Text Articles in Nanoscience and Nanotechnology
Wear Resistant Polydopamine/Ptfe Nanoparticle Composite Coating For Dry Lubrication Applications, Samuel George Beckford
Wear Resistant Polydopamine/Ptfe Nanoparticle Composite Coating For Dry Lubrication Applications, Samuel George Beckford
Graduate Theses and Dissertations
This dissertation presents an investigation into the effect of nanoparticle fillers and a polydopamine adhesive primer on the tribological performance of thin PTFE films. The principal objective of this investigation was to reduce wear in PTFE films, an issue which precludes the use of PTFE films in tribological applications requiring high durability. The friction and wear of the composite films were evaluated using a ball-on-flat configuration in linear reciprocating motion. It was found that the use of a polydopamine adhesive primer reduces the wear of PTFE films more than 600 times. X-ray photoelectron spectroscopy (XPS) results show that a tenacious …
Identification Of Multiple Oscillation States Of Carbon Nanotube Tipped Cantilevers Interacting With Surfaces In Dynamic Atomic Force Microscopy, Mark Strus, Arvind Raman
Identification Of Multiple Oscillation States Of Carbon Nanotube Tipped Cantilevers Interacting With Surfaces In Dynamic Atomic Force Microscopy, Mark Strus, Arvind Raman
Birck and NCN Publications
Carbon nanotubes (CNTs) have gained increased interest in dynamic atomic force microscopy (dAFM) as sharp, flexible, conducting, nonreactive tips for high-resolution imaging, oxidation lithography, and electrostatic force microscopy. By means of theory and experiments we lay out a map of several distinct tapping mode AFM oscillation states for CNT tipped AFM cantilevers: namely, noncontact attractive regime oscillation, intermittent contact with CNT slipping or pinning, or permanent contact with the CNT in point or line contact with the surface while the cantilever oscillates with large amplitude. Each state represents fundamentally different origins of CNT-surface interactions, CNT tip-substrate dissipation, and phase contrast …
Static Friction And Surface Roughness Studies Of Surface Micromachined Electrostatic Micromotors Using An Atomic Force/Friction Force Microscope, Sriram Sundararajan, Bharat Bhushan
Static Friction And Surface Roughness Studies Of Surface Micromachined Electrostatic Micromotors Using An Atomic Force/Friction Force Microscope, Sriram Sundararajan, Bharat Bhushan
Sriram Sundararajan
A technique to measure the static friction forces (stiction) encountered in surface micromachined micromotors using a commercial atomic force microscope (AFM)/friction force microscope has been developed and is described. An AFM tip is pushed against a rotor arm of the micromotor so as to generate lateral deflection (torsion) of the tip, which is measured by the AFM. The maximum value of the lateral deflection obtained prior to rotor movement (rotation) is a measure of the static friction force of the micromotors. This technique was employed to study the effect of humidity and rest time on the static friction force of …