Mining Engineering Commons^™

Characterization And Numerical Simulation Of The Microstructural And Micromechanical Viscoelastic Behavior Of Oil Sands Using The Discrete Element Method, Eric Kofi Gbadam

Doctoral Dissertations

"Oil sands are naturally geologic formations of predominantly quartz sand grains whose void spaces are filled with bitumen, water, and dissolved gases. The electric rope shovel is the primary equipment used for excavating the Athabasca oil sand formations. The equipment's static and dynamic loads are transferred to the formation during excavation and propel. These loads cause ground instability leading to sinkage or rutting, crawler wear, and fracture failures. These problems result in unplanned downtimes, production losses, and high maintenance costs. In order to address these problems, there is a need to develop valid models that capture the behavior and performance …

The Influence Of Caprock On Blast Fragmentation Distribution, Matthew Kurtis Coy

Doctoral Dissertations

"This dissertation describes the development of a small-scale model of a caprock-laden quarry blast and discusses the results from that testing. The purpose of this testing was to provide insight into the reasons for poor caprock breakage during blasting.

Small-scale test blocks were poured using a weak mortar mix to represent a limestone formation at a small scale. A cold joint was created in the upper portion of the test specimens to represent the bedding plane that separates caprock and substrate layers in a caprock-laden limestone bench. The scale-model test blocks were blasted using detonating cord. The primary configuration for …

Modeling Dynamic Community Acceptance Of Mining Using Agent-Based Modeling, Mark Kofi Boateng

Doctoral Dissertations

"This research attempts to provide fundamental understanding into the relationship between perceived sustainability of mineral projects and community acceptance. The main objective is to apply agent-based modeling (ABM) and discrete choice modeling to understand changes in community acceptance over time due to changes in community demographics and perceptions. This objective focuses on: 1) formulating agent utility functions for ABM, based on discrete choice theory; 2) applying ABM to account for the effect of information diffusion on community acceptance; and 3) explaining the relationship between initial conditions, topology, and rate of interactions, on one hand, and community acceptance on the other …

Thermomechanical Fatigue Life Investigation Of An Ultra-Large Mining Dump Truck Tire, Wedam Nyaaba

Doctoral Dissertations

The cost benefits associated with the use of heavy mining machinery in the surface mining industry has led to a surge in the production of ultra-large radial tires with rim diameters in excess of 35 in. These tires experience fatigue failures in operation. The use of reinforcing fillers and processing aids in tire compounds results in the formation of microstructural inhomogeneity in the compounds and may serve as sources of crack initiation in the tire. Abrasive material cutting is another source of cracks in tires used in mining applications. It suffices, then, to assume that every material plane in the …

Pillar Design For St. Peter Sandstone Formation, Francis Anohomah Arthur

Doctoral Dissertations

"Silica sands produced primarily from St. Peter Sandstone are used for hydraulic fracturing in the petroleum industry, glassmaking, chemicals, ceramics, filtration and the foundry industry in the US. The recent high demand for silica sands for hydraulic fracturing has triggered increased production and commissioning of new silica sand mines to support natural gas production from shale and tight gas deposits in the US. Most mines use surface mining methods to extract St. Peter Sandstone. The room and pillar mining method has been successfully used for St. Peter Sandstone mining in a few US locations, however, no one has proposed a …

Lhd Vibrations Analysis And Numerical Modeling During Operations, Kgosietsile Kolobe

Doctoral Dissertations

"Load-haul-dump vehicles (LHDs) are extensively used as primary loaders in mining operations. LHDs have proven to be vigorous, extremely productive and reliable in mining applications. They have a wide range of tramming capacities that have enabled them to become an essential component in the hard rock mining industry.

Increased mining economic challenges and global competition means the mining industry has to maximize productivity by cutting down operating and capital costs. Also, improvements in safety standards have led to the demand for safer and efficient machines.

LHD operators are at a high risk of whole-body vibrations (WBVs) exposure leading to musculoskeletal …

Real-Time Diesel Particulate Matter Monitoring In Underground Mine Atmospheres, Association With The Standard Method And Related Challenges, Muhammad Usman Khan

Doctoral Dissertations

"Diesel-powered equipment is a significant component of underground mining operations. Miners' exposure to diesel exhaust is harmful. The standard Diesel Particulate Matter (DPM) monitoring method (NIOSH 5040 method) has limitations that preclude rapid DPM estimation and detailed understanding of DPM variations over time. However, real-time DPM monitors do not inherit these limitations. Biodiesel is often used as a substitute for regular petroleum-diesel because of its ability to emit less DPM. However, accuracy of available real-time DPM monitors has not been determined in mines using 70% to 99% (high-percent) biodiesel. The present research addresses this need by rigorous testing of a …