Open Access. Powered by Scholars. Published by Universities.®

Mining Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Mining Engineering

Investigation Of Long Term Pillar Stability In An Abandoned Gypsum Mine Based On Dissolution Models, Mohammadhossein Sadeghiamirshahidi Jan 2019

Investigation Of Long Term Pillar Stability In An Abandoned Gypsum Mine Based On Dissolution Models, Mohammadhossein Sadeghiamirshahidi

Dissertations, Master's Theses and Master's Reports

The abandoned Domtar Mine in Grand Rapids, MI underlies Interstate I-196. The mine operated for over 140 years, mining a 30-meter-deep, four-meter thick gypsum seam. In 2000, the mine was abandoned with the removal of the mine’s dewatering pumps allowing groundwater to flood the mine. The initial flooding resulted in saturating the mine pillars along with some amount of pillar dissolution. Overtime, gypsum dissolution would cease as the water becomes saturated with the gypsum dissolution products. The mine, however, is located adjacent to the Grand River and has groundwater moving through the mine resulting in the potential for continuing ...


Electromagnetic Signal Feedback Control For Proximity Detection Systems, Adam K. Smith Jan 2017

Electromagnetic Signal Feedback Control For Proximity Detection Systems, Adam K. Smith

Dissertations, Master's Theses and Master's Reports

Coal is the most abundant fossil fuel in the United States and remains an essential source of energy. While more than half of coal production comes from surface mining, nearly twice as many workers are employed by underground operations.

One of the key pieces of equipment used in underground coal mining is the continuous mining machine. These large and powerful machines are operated in confined spaces by remote control. Since 1984, 40 mine workers in the U. S. have been killed when struck or pinned by a continuous mining machine. It is estimated that a majority of these accidents could ...


Controlling Properties Of Agglomerates For Chemical Processes, Joseph A. Halt Jan 2017

Controlling Properties Of Agglomerates For Chemical Processes, Joseph A. Halt

Dissertations, Master's Theses and Master's Reports

Iron ore pellets are hard spheres made from powdered ore and binders. Pellets are used to make iron, mainly in blast furnaces. Around the time that the pelletizing process was developed, starch was proposed as a binder because it’s viscous, adheres well to iron oxides, does not contaminate pellets and is relatively cheap. In practice, however, starch leads to weak pellets with rough surfaces – these increase the amount of dust generated within process equipment and during pellet shipping and handling. Thus, even though the usual binder (bentonite clay) contaminates pellets, pelletizers prefer it to starch or other organics.

This ...


A Petrophysical Evaluation For Permeability Of A Gas Reservoir In The Taranaki Basin, New Zealand, Musa Cetin Jan 2016

A Petrophysical Evaluation For Permeability Of A Gas Reservoir In The Taranaki Basin, New Zealand, Musa Cetin

Dissertations, Master's Theses and Master's Reports

The goal of this study was to evaluate permeability and study the controls on permeability in a gas saturated formation. Conventional well logs, mineral identification crossplots and empirical models were applied to analyze different lithologic and diagenetic features and to examine the effect that these features may have on the reservoir. An unusual feature was observed, and required detailed examination: there existed (in two wells) five zones of lower resistivity (higher water saturation) above the gas-water contact. This is unexpected, as above that contact, the water is usually at irreducible water saturation. I conclude that the lower resistivity (the higher ...