Mining Engineering Commons^™

The Effects Of Physical Flash Hole Deviations On Factory-Grade Rifle Ammunition, Nicolaas Martin Schrier

Masters Theses

"The objective of this research is to determine the effect of dimensional and positional changes of the primer flash hole on the performance of factory-grade rifle ammunition. The studied variables were flash hole diameter, offset from center, and orientation of the offset in the primer pocket. Cartridge performance was quantified by measuring muzzle velocity, chamber pressure, and target grouping size (precision).

Five different flash hole diameters were tested for both the Remington .223 and Winchester .308 calibers: 1.4mm, 2.0mm (the Fiocchi standard), 2.4mm, 2.8mm, and 3.0mm. Each diameter was tested at three offsets: centered (no offset), 0.5mm from center, and …

The Effects Of Short Delay Times On Rock Fragmentation In Bench Blasts, Margaret Ruth Hettinger

Masters Theses

"Optimized rock fragmentation is essential for minimizing downstream costs to mining operations. Photographic fragmentation analysis, vibration monitoring, and high-speed video all provide measurements of blast effectiveness and supply data that allows operations to modify blasts to achieve downstream goals.

This study evaluates the effects of short hole-to-hole delay times on rock fragmentation. Photographic fragmentation analysis and various delay times were used on the same bench blast, the effects of timing on fragmentation were determined. This analysis provides a representative understanding of timing effects on fragmentation in the field, different from previous blast models which either negate the effects of timing …

Analysis Of Effects Of Surface Roughness And Local Surface Imperfections On Measured Pressure, Laurin Ashley Bookout

Doctoral Dissertations

"When tests using pressure to characterize the performance or effects of an explosive are conducted in laboratory or other small scale, highly controlled settings, it is expected that any gages will be ideally mounted and there will not be any surface imperfections or roughness near the gage location. However, when explosive tests are scaled up, the test beds typically do not have perfect surfaces. Instead there may be rough surfaces with various types of geometry or situations where it is extremely difficult to get the gage flush mounted with a flat surface. In a time where tests with multiple replications …