Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Computational Investigation Using Bleed As A Method Of Shock Stabilization, Dayle L. Chang
Computational Investigation Using Bleed As A Method Of Shock Stabilization, Dayle L. Chang
Theses and Dissertations
Shock-wave/boundary layer interactions (SWBLI) produce undesirable dynamic loads and separated unsteady flows, adversely impacting the performance and structural integrity of supersonic vehicles. Computational fluid dynamics (CFD) is a successful tool in experimental planning and shows promise as a critical tool in understanding and mitigating negative effects of SWBLI. The goal of this research is to demonstrate the effect of bleed holes on shock stability using the OVERFLOW CFD solver to inform the planning of an Air Force Research Laboratory (AFRL) SWBLI wind tunnel experiment. First, a two-dimensional, flat plate, single-hole configuration was developed. Massflow discrepancies of 14.8% were initially observed …
Heat Transfer To The Inclined Trailing Wall Of An Open Cavity, Orval A. Powell
Heat Transfer To The Inclined Trailing Wall Of An Open Cavity, Orval A. Powell
Theses and Dissertations
Experimental and computational heat transfer investigations were performed on a cavity with an inclined trailing wall (20-degrees to the horizontal), simulating one under investigation for use in a scramjet engine. Heat transfer data are reported in the form of Stanton number obtained using a curve fit to the recorded transient surface temperature history under cold flow conditions. Ascending from the reattachment point, the Stanton number increased by nearly 50% due to flow compression. This effect of flow compression was also evident at the junction of the cavity floor and inclined trailing wall, where the Stanton number also increased by 50%. …