Mechanical Engineering Commons^™

Interaction Between Structures And Fluids, Rahim Falsafi-Haghighi

Dissertations

A finite element model for the study of solid-fluid interaction, with applications in flow-induced vibration analysis of reactor vessel and heat exchanger internals, is presented. The model is based on the discretization of the solid equation of motion and the fluid continuity and momentum equations and employs the solid displacements together with the fluid pressure and velocity components as the nodal degrees of freedom. This permits a realistic and accurate implementation of boundary conditions, in contrast with methods using solid displacements and fluid pressure as the only field variables. The numerical solution of the resulting matrix equation, involving non-symetric matrices, …

Dynamics Of Submerged Cylindrical Shells With Eccentric Stiffening, Kerry Kier-Ten Chu

Dissertations

A theoretical analysis is presented for treating the free vibrations of submerged, ring stiffened cylindrical shells with simply supported ends. The effects of the eccentric stiffeners are averaged over the thin-walled isotropic cylindrical shell. The energy method is utilized and the frequency equation is derived by Hamilton's Principle. All three degrees of freedom are considered. Numerical results are presented for frequencies and mode separation for several cases of interest. Comparisons with previous theoretical and experimental results indicate good agreement. The cylindrical wave approximation and the plane wave approximation for the field equation were investigated. Their applicability was evaluated and the …

Deposition Of Suspensions In Laminar Flow In The Entrance Region Of Channels With Diffusive, Electrostatic And Gravitational Effects, Thomas Anthony Korjack

Dissertations

This investigation entailed the consideration of the deposition of suspensions in laminar flow in the entrance region of a parallel-plate channel, and both converging and diverging channels, under the combined influences of diffusive, electrostatic and gravitational effects. The fluid phase was assumed to be incompressible, steady and laminar; the particle phase was assumed to be steady, laminar, dilute, and with negligible lift force.

The complete solution of the problem involved solving the boundary layer equations for the completely viscous fluid phase, and the particulate momentum, continuity and potential equations for the particle phase. Since the resulting equations are non-linear partial …

Axisymmetric Air Jet Impinging On A Hemispherical Concave Plate, Stefan Jachna

Dissertations

This experimental study was conducted on an axisymmetric air jet impinging normally on a smooth, hemispherical, concave plate. The jet Reynolds numbers, based on bulk nozzle velocity and nozzle exit air properties, were between 14,000 and 75,000.

The impingement plate used in this work was a hemispherical surface with the radius of 94 mm.

Calibrated Pitot tubes and a micromanometer were used for pressure and velocity measurements. The Pitot tubes were mounted on precision positioning mechanisms permitting the accurate traversing of any direction in space. The test air flow rate was measured with calibrated rotometers.

The following results of this …