Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Static Friction And Surface Roughness Studies Of Surface Micromachined Electrostatic Micromotors Using An Atomic Force/Friction Force Microscope, Sriram Sundararajan, Bharat Bhushan
Static Friction And Surface Roughness Studies Of Surface Micromachined Electrostatic Micromotors Using An Atomic Force/Friction Force Microscope, Sriram Sundararajan, Bharat Bhushan
Sriram Sundararajan
A technique to measure the static friction forces (stiction) encountered in surface micromachined micromotors using a commercial atomic force microscope (AFM)/friction force microscope has been developed and is described. An AFM tip is pushed against a rotor arm of the micromotor so as to generate lateral deflection (torsion) of the tip, which is measured by the AFM. The maximum value of the lateral deflection obtained prior to rotor movement (rotation) is a measure of the static friction force of the micromotors. This technique was employed to study the effect of humidity and rest time on the static friction force of …
Development Of A Continuous Microscratch Technique In An Atomic Force Microscope And Its Application To Study Scratch Resistance Of Ultrathin Hard Amorphous Carbon Coatings, Sriram Sundararajan, Bharat Bhushan
Development Of A Continuous Microscratch Technique In An Atomic Force Microscope And Its Application To Study Scratch Resistance Of Ultrathin Hard Amorphous Carbon Coatings, Sriram Sundararajan, Bharat Bhushan
Sriram Sundararajan
A method to measure friction during scratching at linearly increasing loads in a commercial atomic force/friction force microscope (AFM/FFM) has been developed. The normal load was increased in small increments over the required range for the scratch using a software module while the friction signal was measured via a breakout box and data acquisition computer. Topography images of the scratch were obtained in situ with the AFM in tapping mode with minimal loss of damage event information. This technique was employed to study the scratch resistance of hard amorphous carbon coatings of thicknesses ranging from 20 nm down to 3.5 …