Mechanical Engineering Commons^™

Potential Energy Generation From Agricultural Residue In Indonesia, Adrian Rizqi Irhamna

English Language Institute

Indonesia has great potential of biomass sources from their agricultural residue, which can potentially be used for alternative energy generation. This preliminary research explores the most suitable technology for energy generation from agricultural residue and its challenge for application in Indonesia. The study showed that biomass utilization via the direct combustion process is recommended for energy generation. It is also reported that the pretreatment process of drying and washing, are required to increase the fuel quality and plant efficiency.

Literature Survey Of Wet-Waste And Hydrothermal Carbonization System: A Comparative Evaluation, Ramat Olaide Yusuf

Dissertations and Theses

This thesis describes the process of Hydrothermal carbonization and a comparative assessment on recent work done on the process using different feedstocks such as Raw Apple (RA), Apple chip pomace (ACP), apple juice pomace (AJP), grape pomace (GP), macadamia nut-shell (MNS), Sewage Sludge (SS), Poultry Litter (PL) and Grape Marc (GM). The data obtained from the literature survey was compared with the data obtained by the CCL team on the SWPS gasifier (HTC of poultry litter) to obtain how carbon conversion efficiency, syngas composition, thermal efficiency, char production rate, gas production rate and energy utilization vary with carbonization process conditions, …

Heat Transfer Analysis In A Paddle Reactor For Biomass Fast Pyrolyis, Ankith Ullal

Dissertations, Master's Theses and Master's Reports

Heat transfer analysis was performed on a novel auger reactor for biomass fast pyrolysis. As part of this analysis, correlations for specific heat capacity and heat transfer coefficients for biomass (sawdust) and sand (used as heat transfer medium) were developed. For sand, the heat transfer coefficient followed a power law distribution with reactor fill level and temperature. For raw biomass, the heat transfer coefficient also showed similar dependence on fill level, but was independent of temperature up to 300°C. These correlations were used in a one dimensional heat transfer model developed to calculate the heating time and heating rate of …

Experimental Investigation Of Fast Pyrolysis Of Arundo Donax In A Novel Paddle Reactor, Chintan Desai

Dissertations, Master's Theses and Master's Reports

The main objective of this research was to show the effectiveness of a novel paddle reactor for fast pyrolysis and study the effect of biomass particle size and reaction temperature of Arundo Donax a type of energy crop on the bio-oil yields. The novel paddle reactor showed effective mixing and heat transfer which were proved with the help of studying the residence time and the heating characteristics of the system respectively. The effect of different biomass particle sizes on the bio-oil yield was not significant, the bio-oil yield was approximately 50% for all the sizes. For Arundo Donax particle sizes …

Effects Of Biomass Moisture Content On Volatile Flame Length During Cofiring With Coal, Matthew Pollard

McKelvey School of Engineering Theses & Dissertations

Cofiring biomass with coal can contribute to meeting Renewable Portfolio Standards (RPS) and reduce pollutant emissions. The physical characteristics and composition of biomass can vary significantly, which can affect the combustion characteristics. When cofiring biomass with coal, these differences can impact the structure of the volatile flame, the region where combustion of volatiles dominates. The length and location of the volatile flame is important to flame stability and determines the location and extent of volatile release. This has an effect on pollutant emissions, such as NOx (nitrogen oxides). Previously, the effects of parameters such as cofiring ratio, particle size, and …

The Role Of Surface Area In Catalytic Gasification Of Biomass, Elizabeth A. Wachs, Nitish Kumar, Indraneel Sircar, Prithviraja Basak, Jay P. Gore Phd

The Summer Undergraduate Research Fellowship (SURF) Symposium

Gasification of biomass has the potential to provide a carbon-negative source of liquid fuels. The current limited use of gasification is due in part to the high temperatures necessary to achieve high conversion levels. These temperatures can be lowered by the use of catalysts, but the mechanisms by which catalysts affect the reaction rate are not fully understood. Here, the structural component of potassium carbonate’s role in the gasification process was examined. Samples of pinewood sawdust were impregnated with potassium carbonate, then pyrolyzed with N2 in a fixed bed reactor at 750°C (heater thermocouple reading). Half of the char was …

Determination Of Kinetic Parameters From The Thermogravimetric Data Set Of Biomass Samples, Karol Postawa, Wojciech M. Budzianowski

Wojciech Budzianowski

This article describes methods of the determination of kinetic parameters from the thermogravimetric data set of biomass samples. It presents the methodology of the research, description of the needed equipment, and the method of analysis of thermogravimetric data. It describes both methodology of obtaining quantitative data such as kinetic parameters as well as of obtaining qualitative data like the composition of biomass. The study is focused mainly on plant biomass because it is easy in harvesting and preparation. Methodology is shown on the sample containing corn stover which is subsequently pyrolysed. The investigated sample show the kinetic of first order …

Analysis Of Biomass/Coal Co-Gasification For Integrated Gasification Combined Cycle (Igcc) Systems With Carbon Capture, Henry A. Long Iii

University of New Orleans Theses and Dissertations

In recent years, Integrated Gasification Combined Cycle Technology (IGCC) has become more common in clean coal power operations with carbon capture and sequestration (CCS). Great efforts have been spent on investigating ways to improve the efficiency, reduce costs, and further reduce greenhouse gas emissions. This study focuses on investigating two approaches to achieve these goals. First, replace the subcritical Rankine steam cycle with a supercritical steam cycle. Second, add different amounts of biomass as feedstock to reduce emissions. Finally, implement several types of CCS, including sweet- and sour-shift pre-combustion and post-combustion.

Using the software, Thermoflow®, this study shows that utilizing …