Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Mechanical Engineering
Kinetic Modeling Of Catalytic Aerogels, Yi Cao
Kinetic Modeling Of Catalytic Aerogels, Yi Cao
Honors Theses
As pollution becomes an increasing concern globally, strict regulations have been set on vehicle pollutant emissions. The three-way catalytic converter is capable of converting toxic emissions such as carbon monoxide, unburned hydrocarbons and nitrogen oxides to less hazardous waste such as carbon dioxide, water, and nitrogen. Current catalysts employ platinum group metals, which are expensive and environmentally damaging to mine. Catalytically-active aerogels such as Co-Al, Cu-Al and V-Al aerogels have shown promise as alternatives to these metals. The work presented here adapts and extends a global kinetic model which predicts the conversion of hydrocarbons and carbon monoxide on platinum catalyst …
Looking For Small Changes In Heat Capacity Using A Differential Scanning Calorimeter, Will Linthicum
Looking For Small Changes In Heat Capacity Using A Differential Scanning Calorimeter, Will Linthicum
Honors Theses
One of the major difficulties in development of renewable energy is the lack of an adequate and economical means of energy storage. In the case of concentrated solar power a large mass of thermal fluid is required to store a reasonable amount of energy. This is primarily because the fluids tend to have a low specific heat capacity. Formulating composites of these fluids can enhance their specific heat capacity and avails opportunities to make concentrated solar power more attractive. In most cases, the specific heat capacity of composite materials is a weighted average of the individual component heat capacities. This, …
Manual Rubber Sandal Press For Loisaba Kenya, Bridget N. Little
Manual Rubber Sandal Press For Loisaba Kenya, Bridget N. Little
Honors Theses
The goal of this project was to develop an inexpensive manual cutting machine to cut sandals out of recycled tires and industrial belt allowing poor Kenya villages to produce their own sandals that are durable enough to survive the rough terrain. In Kenya 56 percent of the population live in poverty, surviving on less than a dollar a day. Walking is the main mode of transportation and the majority of Kenyans can only afford second hand shoes that wear out easily on the unpaved roads. In developing this machine the goal was to make the machine affordable for a company …