Mechanical Engineering Commons^™

Development Of A Novel Microreactor For Improved Chemical Reaction Conversion, Yu Liang

Doctoral Dissertations

Microreactors have been widely studied over the past two decades for different chemical reactions, to develop new analytical capabilities, and to obtain high mixing performance in the reactors. The main objectives of this work are to investigate the effect of different microchannel structures on the fluid properties and mixing behavior in microreactors, and to design, fabricate, and test a novel microreactor for higher conversion in a chemical reaction. The development of this novel microreactor is intended to provide a valuable guideline in achieving enhanced chemical mixing and to make available a solid research base for optimization of the yield of …

Layer-By-Layer Nanoassembly Combined With Microfabrication Techniques For Microelectronics And Microelectromechanical Systems, Jingshi Shi

Doctoral Dissertations

The objective of this work is to investigate the combination of layer-by-layer self-assembly with microfabrication technology and its applications in microelectronics and MEMS.

One can assemble, on a standard silicon wafer, needed multilayers containing different nanoparticles and polymers and then apply various micromanufacturing techniques to form microdevices with nanostructured elements.

Alternate layer-by-layer self-assembly of linear polyions and colloidal silica at elevated temperatures have been firstly studied by QCM and SEM. LbL self-assembly and photolithography were combined to fabricate an indium resistor. The RTA method was employed in the fabrication. Hot-embossing technique as a reasonably fast and moderately expensive technique was …

Fatigue Of Drill Pipes Used In Horizontal Directional Drilling, Feibai Ma

Doctoral Dissertations

Fatigue is the most common cause of mini-HDD drill rod failure. It can occur at stress levels far below the normal operating stress in most drill stem components. Fatigue failures occur because the drill rod, after it has been forced into a curved path, undergoes a cyclic bending stress oscillating from tension to compression in concert with the other stress components caused by torque, thrust, or pullback.

When a rod breaks underground, there is considerable extra cost caused by the delay in “fishing” out the broken rod as well as the cost of replacing the rod. On the other hand, …

Mathematical Modeling For Fabricating A Microstructure With A Pre-Specified Geometry Using Laser -Induced Chemical Vapor Deposition, Chaoyang Zhang

Doctoral Dissertations

Laser-induced chemical vapor deposition (LCVD) is an emerging new technique with many practical applications. To optimize the system for fabricating a microstructure with a pre-specified geometry in pyrolytic LCVD, a three-dimensional mathematical model is developed for predicting temperature distributions and laser dwell times across the substrate scanned by the laser beam. A microstructure is fabricated layer by layer, and for each layer the laser beam moves from one pixel to the next. The complicated correlations among temperature distribution, deposit growth rate, and laser dwell time are investigated. A purely heterogeneous reaction is assumed and any gas-phase transport is ignored.

A …