Open Access. Powered by Scholars. Published by Universities.®

Other Materials Science and Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 6 of 6

Full-Text Articles in Other Materials Science and Engineering

Rheological Properties And Structural Build-Up Of 3d Printed Magnesium Potassium Phosphate Cement, Hui Zhi Zhao Jul 2022

Rheological Properties And Structural Build-Up Of 3d Printed Magnesium Potassium Phosphate Cement, Hui Zhi Zhao

International Conference on Durability of Concrete Structures

This paper focuses on the rheological properties of 3D printed magnesium potassium phosphate cements (MKPCs) with different magnesium-to-phosphate (M/P) mass ratio, MgO fineness and supplementary cementitious materials (SCMs) types. The variable shear rate tests were used to monitor the extrudability. The highest slope of the evolution of storage modulus (G') and the maximum static yield stress (Mτs) value were used as an indication of the rigidification rate. The increased M/P mass ratio, MgO fineness and SCMs addition resulted in the promoted structural build-up of 3D printed MKPCs. The consistency between the evolution of G' and Mτs with …


Mechanical Properties And Microstructure Of High Strength Lc3 Pastes With Varying Limestone/Calcined Clay Ratios And Different Curing Conditions, Yemin Dong Jul 2022

Mechanical Properties And Microstructure Of High Strength Lc3 Pastes With Varying Limestone/Calcined Clay Ratios And Different Curing Conditions, Yemin Dong

International Conference on Durability of Concrete Structures

研究(抗施工蒸馏)石石和石榴石在淀粉胶系统(即0标准和低水印)下的水胶系统(即0标准和低水墨)X射线比、水量值水量-电子背基相关研究.61.25 .25.25.25.0.25.25.25.25.25.0.25.25.25.25.25.1.25.7.25.0.0.0.0.0.0.0.0.0.0.0.0.0.0.1.25.1.25.25.1.25.1.25.1.25.1.25.1.25.1 .25.1.25.1.25.1.25.1.25.1.25.0.0.0.0.0.0.0.00.0.0.1.25.1.25.1.25.1.25.1.25.0.0.0.00.0.0.0.0.0.0.0.0.0.0.0.0.0.00.0 .00.0.00.X射线比值、水量-电子显微镜相关研究测量值。早期的水泥水化程度小水的压合含煤量,降低了水泥石的。因此,需要采用合适的钙铝内容和体系以提高碳系统的性能。


Mechanical And Thermal Insulation Properties Of Clay-Based Lightweight Concrete, Chuang Shi, Chuanlin Hu Jul 2022

Mechanical And Thermal Insulation Properties Of Clay-Based Lightweight Concrete, Chuang Shi, Chuanlin Hu

International Conference on Durability of Concrete Structures

建材生产和住宅采暖将消耗大量能源并排放大量CO2。在混凝土制备中,使用陶土制备具有优异隔热性能的轻质混凝土,并使用煅烧粘土代替部分波特兰水泥,可以大大降低能耗。本研究采用页岩陶土和陶砂分别作为粗骨料和细骨料制备轻质混凝土。首先,确定最佳体积砂比。然后,使用煅烧粘土和石灰石的剂量从30%,50%到70%。研究了煅烧粘土和石灰石含量对混凝土微观结构、力学性能和隔热性能的影响。结果表明,最佳体积砂比为50%。当煅烧粘土和石灰石的用量为30%时,强度在所有年龄段最高,28 d时强度可达33.6 MPa,比对照组高12%。当更换水平不断增加时,所有年龄段的实力开始下降。所制备的粘土基轻质混凝土的导热系数低至0.144 W/mK,表现出优异的保温性能。本研究制备的轻质混凝土具有较高的强度和优异的保温性能,具有良好的应用前景。


The Effect Of Calcium Nitrate On The Hydration Of Calcium Aluminate Cement At Different Curing Temperatures, Hongxia Wang, Guizhi Diao, Guanghua Liu, H Wang, Lixiong Gao, Guangwei Liu Nov 2019

The Effect Of Calcium Nitrate On The Hydration Of Calcium Aluminate Cement At Different Curing Temperatures, Hongxia Wang, Guizhi Diao, Guanghua Liu, H Wang, Lixiong Gao, Guangwei Liu

International Conference on Durability of Concrete Structures

Phase conversion in calcium aluminate cements (CAC) induces significant volumetric instability; it would result in an increase in porosity and decrease in strength in CAC. In this study, calcium nitrate (CN) as a phase conversion inhibitor, the effect of CN on the hydration of CAC at different curing temperatures was studied. Xray diffraction, thermal analysis, SEM, isothermal calorimetry and the compressive strength were conducted on the CAC dosages of 0%, 5%, 10% and 15%CN cured at 20�, 30�, 40� and 50�. The results show CN can retard CAC hydration, alter the characters of the hydrates of CAC systems and avoid …


Carbon Fiber As Anode Material For Cathodic Prevention In Cementitious Materials, Emma Qingnan Zhang, Luping Tang, Thomas Zack Jun 2016

Carbon Fiber As Anode Material For Cathodic Prevention In Cementitious Materials, Emma Qingnan Zhang, Luping Tang, Thomas Zack

International Conference on Durability of Concrete Structures

Cathodic prevention (CPre) technique is a promising method and has been used for the past two decades to prevent steel from corrosion in concrete structures. However, wide application of this technique has been restricted due to high costs of anode materials. In order to lower the cost and further improve this technique, carbon fiber composite anode has been introduced as an alternative anode material with affordable price and other outstanding properties. This paper presents the study of using carbon fiber mesh as anode material for long-term cathodic prevention system and the effect of accelerated current on macro- and microstructure of …


Finite Volume Numerical Analysis Of The Thermal Property Of Cellular Concrete Based On Two And Three Dimensional X-Ray Computerized Tomography Images, She Wei, Yang Yonggan, Xie Deqing, Zhang Yunsheng Jul 2014

Finite Volume Numerical Analysis Of The Thermal Property Of Cellular Concrete Based On Two And Three Dimensional X-Ray Computerized Tomography Images, She Wei, Yang Yonggan, Xie Deqing, Zhang Yunsheng

International Conference on Durability of Concrete Structures

Cellular concrete is one kind of lightweight concrete, which are widely used in thermal insulation engineering project. In this study, a three dimensional (2D and 3D) finite-volume-based models was developed for analyzing the heat transfer mechanisms through the porous structures of cellular concretes under steady-state heat transfer condition and also for investigating the differences between 2D and 3D modeling results. 2D and 3D reconstructed pore networks were generated from the microstructural information measured by a 3D image captured by X-ray computerized tomography (X-CT). In addition, the 3D-computed value of the effective thermal conductivity was found to be in better agreement …