Geological Engineering Commons^™

Seismic Azimuthal Anisotropy Beneath A Fast Moving Ancient Continent: Constraints From Shear Wave Splitting Analysis In Australia, Kailun Ba, Stephen S. Gao, Jianguo Song, Kelly H. Liu

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

Seismic Azimuthal Anisotropy Beneath Australia is Investigated using Splitting of the Teleseismic PKS, SKKS, and SKS Phases to Delineate Asthenospheric Flow and Lithospheric Deformation Beneath One of the Oldest and Fast-Moving Continents on Earth. in Total 511 Pairs of High-Quality Splitting Parameters Were Observed at 116 Seismic Stations. Unlike Other Stable Continental Areas in Africa, East Asia, and North America, Where Spatially Consistent Splitting Parameters Dominate, the Fast Orientations and Splitting Times Observed in Australia Show a Complex Pattern, with a Slightly Smaller Than Normal Average Splitting Time of 0.85 ± 0.33 S. on the North Australian Craton, the Fast …

An Integrated Wellbore Stability Study To Mitigate Expensive Wellbore Instability Problems While Drilling Into Zubair Shale/Sand Sequence, Southern Iraq, Ahmed Khudhair Abbas

Doctoral Dissertations

”The Zubair Formation is the most prolific reservoir in Iraq, which is comprised of sandstones interbedded with shale sequences. Due to the weak nature of the shale sequence, the instability of a wellbore is one of the most critical challenges that continuously appears during drilling across this formation. Historically, over 90% of wellbore problems in the Zubair Formation were due to wellbore instability. Problems associated with wellbore instability, such as tight hole, shale caving, stuck logging tools along with subsequent fishing, stuck pipe, and sidetracking result in increasing the non-productive time. This non-productive time has cost an enormous amount of …

Predictive Geohazard Mapping Using Lidar And Satellite Imagery In Missouri And Oklahoma, Usa, Olufeyisayo B. Ilesanmi

Doctoral Dissertations

”Light Detection and Ranging (LiDAR) and satellite imagery have become the most utilized remote sensing technologies for compiling inventories of surficial geologic conditions. Point cloud data obtained from multi-spectral remote sensing methods provide a detailed characterization of the surface features, in particular, the detailed surface manifestations of underlying geologic structures. When combined, point clouds eliminate bias from visual inconsistencies and/or statistical values. This research explores the competence of point clouds derived from LiDAR and Unmanned Aerial Systems (UAS) as a predictive tool in evaluating various geohazards. It combines these data sets with other remote sensing techniques to evaluate the sensitivity …

Spectral Analysis Of Surface Waves To Detect Subsurface Voids, Payman Hajiani, Neil Lennart Anderson, J. David Rogers

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

Systems and methods for detecting a subsurface cavity. A source applies a force to ground under inspection and a plurality of sensors coupled to the ground detect resulting surface waves. A processor is configured to extract phase and frequency components of the acquired seismic data, identify a phase shift in surface waves in the ground under inspection based on the extracted phase and frequency components, and determine one or more physical characteristics of a subsurface cavity based on the identified phase shift

Development Of A Variogram Approach To Spatial Outlier Detection Using A Supplemental Digital Elevation Model Dataset, Zane Daniel Helwig

Masters Theses

"When developing a ground water model, the quality of the dataset should first be evaluated. Spatial outliers can lead to predictions which are not representative of actual conditions. In order to isolate misrepresentative points, a method is presented which examines the experimental variogram of a ground water elevation dataset. To define a threshold variance between pairs of ground water elevation measures, ground elevation values from a digital elevation model (DEM) are used to determine a maximum reasonable variance expected to occur on the experimental variogram. To determine appropriate DEM parameters, a separate study was also done which observed characteristic behavior …

Mining Asteroids For Volatile Resources: An Experimental Demonstration Of Extraction And Recovery, Egboche Christopher Unobe

Masters Theses

"Gaseous compounds trapped within carbonaceous asteroids may prove to be important targets for prospective space miners in the near-term. Volatile release is from hydrated, hydroxylated and carbonated phases present, making such bodies attractive as feedstock for the production of H₂O, CO₂ and simple organic compounds. A source of these species in orbit provides an opportunity to locally produce space-craft propellant and other life-support gases through the application of In-situ Resource Utilization (ISRU).

For this study, an experimental vacuum system was modified and used to test the technical validity of radiatively heating asteroid simulants to extract contained gaseous …

Assessment Of Rockfall Rollout Risk Along Varying Slope Geometries Using The Rocfall And Crsp Software, Mariam S. Al E'Bayat

Masters Theses

"Most routes in mountainous areas suffer from rock falling, rolling and bouncing risk. There are many computer programs concerned with simulating the rockfall problem, and whereas they have the same purpose, they however differ in the input data that's needed to simulate the problem, and they also differ in the way of processing and kind of output.

This study used Rocfall® and the Colorado Rockfall Simulation Program (CRSP®) to simulate sixty-three models of varying slope geometry, where only the slope geometry is changed with the same material properties for both the slope and the rocks.

Both programs were fast and …

Hydrogeochemical Controls On Reactive And Nonreactive Solute Transport In Heterogenous Porous Media, Mahta Gholizadeh Ansari

Masters Theses

"This work examines how physical and chemical heterogeneity can affect reactive and non-reactive transport in porous media. The effect of heterogeneity of the porous media is investigated both on dissolution rate of magnesite and attenuation time of nonreactive contaminants in non-reactive media. Various spatial distribution were created using statistical parameters in PETREL.A total of 6793 transport modeling simulations were run using CrunchFlow. Lasso regression was used to select most significant features and those features are then used in linear regression and deep learning models.

The magnesite dissolution simulations were performed under different permeability ratios (magnesite /sand permeability) and inlet pH. …

Imaging Reinforced Concrete: A Comparative Study Of Ground Penetration Radar And Rebarscope, Abhishek Kodi

Masters Theses

"Geophysical techniques have been playing a very vital role in subsurface imaging in the recent past. Technology has been making it both reliable and convenient to utilize non-destructive geophysics techniques like Ground Penetration Radar, Induction current based Rebarscope, Seismic methods, ERT, etc. The applications range from shallow subsurface investigation of Bridge decks to old tunnels, mapping of rabars in a pre-existing construction and analyzing the concrete strength.

The thesis constitutes of a comparative study and analysis of a Ground Penetration Radar system and a Rebarscope. Individual parameters obtained directly from the study and obtained indirectly from the study shall be …

Microstructure And Geotechnical Properties Of St. Peter Sandstone In Clayton, Iowa, Amir Hossein Bagherieh

Doctoral Dissertations

"The St. Peter Sandstone is significantly different from the minerals and rocks which have been studied extensively in mining. It is brittle and characterized by an unusually high friction angle. On the other hand it is friable, and it is nearly cohesionless. The scarcity of the ground control techniques for this particular mining environment has created many difficulties for mine operators. This research aims to establish a fundamental understanding of the basic mechanical and strength properties of the St. Peter Sandstone for engineering design and scientific research. The specific objectives are 1) characterizing the strength of the St. Peter Sandstone, …