Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 2 of 2
Full-Text Articles in Engineering Science and Materials
Some Aspects Of The Mechanical Response Of Pmr-15 Neat Resin At 288°C: Experiment And Modeling, Christina M. Falcone
Some Aspects Of The Mechanical Response Of Pmr-15 Neat Resin At 288°C: Experiment And Modeling, Christina M. Falcone
Theses and Dissertations
The mechanical response of PMR-15 neat resin was investigated at 288?C. Monotonic loading/unloading tests performed at several constant stress rates revealed considerable rate dependence, especially on the unloading path. Effect of prior stress rate on creep behavior was evaluated in creep tests preceded by uninterrupted loading to a target stress. Creep response was dependent on the prior stress rate. Effect of loading history was studied in stepwise creep tests, where specimens were subjected to a constant stress rate loading followed by unloading to zero stress with intermittent creep periods during both loading and unloading. Comparison of creep strains accumulated during …
Simultaneous Design Of Active Vibration Control And Passive Damping, Michele Lynn Devereaux Gaudreault
Simultaneous Design Of Active Vibration Control And Passive Damping, Michele Lynn Devereaux Gaudreault
Theses and Dissertations
A modified form of the standard linear quadratic regulator LQR cost functional is used to optimally blend active vibration control and passive structural damping, whether viscous or viscoelastic. Viscoelastic damping is first modelled by a standard linear model, and then by a fractional derivative model. For the viscous damping case and the classically modelled viscoelastic damping case, a sub-optimal closed form solution is derived that is independent of the initial conditions. An iterative technique that minimizes the average value of the cost functional and one that minimizes the maximum value are developed. Both techniques are applicable to viscous and viscoelastic …