Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 3 of 3
Full-Text Articles in Engineering Science and Materials
High Performance Thermal Insulation: Silica Aerogels In Construction Technology, Matthew Giarrusso
High Performance Thermal Insulation: Silica Aerogels In Construction Technology, Matthew Giarrusso
Honors Theses
The United States is a world leader in the production and expenditure of energy, accounting for 18% of the total global energy consumption in 2016, 40% of which was used for the heating, cooling, and lighting of commercial and residential buildings. Currently, traditional air-based insulation products are being used in thicker and more numerous layers in an attempt to keep up with contemporary codes and standards. One promising alternative to traditional insulation is silica aerogel. With a remarkably low density and thermal conductivity, silica aerogel could save energy, space, and weight in new and retrofit structures. Silica aerogels are currently …
Manufacturing A Composite Wheel Prototype Using 3d Printed Molds, Steven Thuening
Manufacturing A Composite Wheel Prototype Using 3d Printed Molds, Steven Thuening
All Graduate Theses, Dissertations, and Other Capstone Projects
Throughout the evolution of high performance racing, a large emphasis has been on reducing the weight of the vehicle in order to improve its performance. Over the years, new designs and materials have been introduced reducing weight in a variety of different locations. Comparing weight reduced in different areas has shown that some areas are more valuable to reduce than others are. Perhaps one of the most beneficial locations are the wheels. This is because the mass of the wheel is considered unsprung and rotational. Because of this, large improvements towards the reduction of wheel mass have been developed in …
Microstructural Characterization Of LensTm Ti-6al-4v: Investigating The Effects Of Process Variables Across Multiple Deposit Geometries, Laura Christine Davidson
Microstructural Characterization Of LensTm Ti-6al-4v: Investigating The Effects Of Process Variables Across Multiple Deposit Geometries, Laura Christine Davidson
Browse all Theses and Dissertations
Laser based additive manufacturing of Ti-6Al-4V components is under consideration for aerospace applications. The mechanical properties of the finished components depend on their microstructure. Process mapping compares process variables such as heat source power, heat source travel speed, material feed rate, part preheat temperature and feature geometry to process outcomes such as microstructure, melt pool geometry and residual stresses. In this work, the microstructure of two-dimensional pads, multilayer pads, thin walls, and structural components at the steady state location was observed. A method for measuring β grain widths that allows for the calculation of standard deviations, confidence intervals, and variances …