Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Publication
- Publication Type
Articles 1 - 2 of 2
Full-Text Articles in Engineering Science and Materials
Effect Of Time Delay Between Etching And Adhesive Bonding (“Outlife” Time) On Lap-Shear Strength Of Aluminum Alloys Using Environmentally-Friendly P2 Etch, Josh Barkhimer, Matthew Erich, Gokul Nair
Effect Of Time Delay Between Etching And Adhesive Bonding (“Outlife” Time) On Lap-Shear Strength Of Aluminum Alloys Using Environmentally-Friendly P2 Etch, Josh Barkhimer, Matthew Erich, Gokul Nair
Materials Engineering
Raytheon Company currently uses a Forest Products Laboratory (FPL) paste etchant for preparing aluminum surfaces for adhesive bonding, and FPL is a source of hazardous hexavalent chromium. The goal of this study was to evaluate a less-toxic P2 paste etchant as a possible replacement. Coupons of 2024-T3, 6061-T6, and 7075-T6 grades of aluminum alloy were solvent-degreased, abrasively cleaned, and etched at room temperature using P2 paste following a strict protocol adopted from Raytheon. Coupons were then left exposed to air for assigned time intervals (or “outlife” times) of 0, 1, 4, 8, 16, and 63 or 72 hours. The aluminum …
Development Of A Metal-Printing 3d Printer At The University Of North Dakota, Benjamin Kading, Michaela Kegley, Tiana Delzer, Jeremy Straub, Scott Kerlin
Development Of A Metal-Printing 3d Printer At The University Of North Dakota, Benjamin Kading, Michaela Kegley, Tiana Delzer, Jeremy Straub, Scott Kerlin
Jeremy Straub
Three-dimensional (3D) printing is being used for numerous applications: from consumer hobbies to the development of aircraft parts. However, inexpensive 3D printers have been constrained in material selection to plastic. These printer use the fused deposition modeling (FDM) method of printing, which is a relatively new technology that utilizes computer numerical control (CNC) techniques to deposit melted material at specific places. Other methods, for example, include laser sintering and stereolithography. With 3D printing, layers are stacked upon each other and via this compilation of layers, a 3D object is formed. Currently there are a variety of materials that can be …